Mazda CX-9 Quick Tips page 9

S E A T S
Manual seat
1. Fore-aft adjustment
Lift lever and hold, slide seat,
release lever.
2. Raise/lower seat
(Driver's seat only)
Pull/push lever and release.
3. Seat back angle
To adjust: Lift and hold lever,
lean forward or backward
to tilt seat, release lever.
4. Manual lumbar adjustment
(Driver's seat only)
Pull lever forward repeatedly
for more support.
5. Head restraint
To raise/lower: Pull up/hold release
button (11) and push down.
Power seat*
6. Seatback angle
Press front/rear of switch.
7. Power lumbar adjustment*
Press front/rear of switch to
increase/decrease lumbar support.
WARNINGS: Do not adjust
seats while driving.
Seat belts must always be
worn when vehicle is in motion.
Air bags are supplemental
and do not replace seat
belt usage.
Always wear your seat belt
and properly secure children
12 and under in the rear seat.
Even with a deactivation
system, never place rear-facing
infant-safety seat in front
of any air bag, an infant is
in serious danger of being
injured or killed.
If you must install a forward-
facing child-safety seat in
the front seating position,
move vehicle seat as far
back as possible.
Always check the Owner's Manual for more operating information and safety features
3
2
1
10 8
9
Shoulder belt
height
adjustment
To raise: Push
adjuster up.
To lower:
Pull button (1),
slide down; release button.
WARNING: Make sure adjuster
locks in one of its positions.
Child-safety seat
To install in rear outboard seats:
Use dual locking mode retractor
seat belts; see Owner's Manual
for proper installation and child
seat tether and LATCH system
instructions.
WARNING: Use age
appropriate child restraints,
see Owner's Manual and
state or province laws.
8. Raise/lower front of seat
5
Pull/push front of switch vertically.
Fore/aft adjustment
11
Slide switch horizontally.
Raise/lower rear of seat
Pull/push rear of switch vertically.
Raise/lower seat
Pull/push center of switch vertically.
4
Seat position memory*
Adjust seat, then press and hold
set button (9), then select and
5
press a memory position button
11
(10) to save setting.
Tip: To program memory seat
into advanced key*/retractable
key, with ignition off; key
removed and driver's door open,
7
press and hold set button (9)
while holding unlock button on
transmitter until beep is heard.
6
Seat belt emergency
locking mode
1
Belts lock only on hard acceleration,
braking, cornering or impacts of
about 5 mph or more.
Automatic locking mode
(all seat belts except
driver's seat belt)
Must be used when installing
child-safety seat.
To activate: Pull webbing fully
out of retractor, allow belt to
retract until click is heard;
belt will only tighten.
To disengage: Unbuckle belt and
allow webbing to retract fully.
*Denotes optional equipment
Seats
Seats