Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Shindaiwa 65010
Summary of Contents for Shindaiwa 65010
- Page 1 SHINDAIWA OWNER’S/OPERATOR’S MANUAL MULTIPURPOSE EDGER TOOL 65010 Minimize the risk of injury to yourself and others! Read this manual and familiarize yourself with the contents. Always wear eye and hearing protection when operating this unit. WARNING! X7502880402 12/10...
-
Page 2: Table Of Contents
If you have questions regarding your Shindaiwa hand held power equipment, or if you do not understand something in this manual, contact your local Shindaiwa dealer for assistance. -
Page 3: Safety
Operating Precautions WARNING! Use Good Judgement This Shindaiwa edger tool is spe- Before starting the engine, make sure ALWAYS stop the engine immedi- cifically designed for use on the the cutting attachment is not contacting ately if it suddenly begins to vibrate Shindaiwa Multipurpose Tool Carrier. -
Page 4: Safety Labels
When operating in rocky terrain or near electric wires or fences, use extreme caution to avoid contacting such items with the cutting attachment. Safety Labels SHINDAIWA OWNER’S/ OPERATOR’S MANUAL 50 FEET MULTIPURPOSE IMPORTANT! (15m) EDGER TOOL... -
Page 5: Product Description
■ “front” and “rear” refer to directions as complete unit: Assembly Tool (s) ■ viewed by the operator during normal Shaft/Gearcase Assembly Carefully inspect all components for operation. ■ Shield/Wheel Assembly damage. 65010-94010_MLE230_07LP 11/21/01, 11:19 AM... -
Page 6: Assembly
Assembly Installing a Tool Attachment Place the Multipurpose Tool Carrier (A) and the Tool Assembly (B) on a clean, flat surface so that both assemblies fit end to end. The powerhead assembly should be facing up, and the tool assembly should be positioned with the lock- ing hole in the tube (C) end facing up. - Page 7 (A). Raise or lower the guide wheel (B) to the desired setting. Tighten the guide wheel adjusting knob firmly. WARNING! Use only Shindaiwa replacement edger blades. WARNING! Never adjust the guide wheel while the engine is running. NOTE: Guide wheel adjustment is also required to compensate for blade wear.
-
Page 8: Using A Hand-Held Edger
If it has been lost or make sure the engine and cutting injury. misplaced, contact Shindaiwa for a attachment are completely stopped. replacement. Disconnect the spark plug wire IMPORTANT before performing service or mainte- nance work. - Page 9 Latch shaft ■ Protector Blades are not interchangeable between Shindaiwa edgers and brush cutter models. Operating any machine with a blade or attachment not Latch approved for that unit can be hazardous and may cause serious injury. 50-hour Maintenance...
-
Page 10: Replacing The Edger Blade
Inspect the Gearcase Protector The metal gearcase protector (L) is installed to protect the gearcase flange from damage when working close to sidewalks or other abrasive surfaces, and should be routinely inspected for damage or excessive wear. When replacing the protector, inspect to be sure that both of the protector mount- ing screws are firmly tightened and each screw is locked in place with a nut as... -
Page 12: Servicing Information
Warranty Registration To ensure trouble free warranty coverage it is important that you register your Shindaiwa equipment by filling out the warran- ty registration card supplied with your unit. Registering your product confirms your warranty coverage and provides a direct link if we find it necessary to contact you.
Need help?
Do you have a question about the 65010 and is the answer not in the manual?
Questions and answers