Ipod Or Iphone Playback - Sharp XL-HF201P Operation Manual

Listening to the iPod, iPhone or iPad
The message "This accessory is not made to work with
iPhone" or similar, may appear on the iPhone screen when:
- battery is low.
- the iPhone is not properly docked (eg. slanting).
If this occurs, remove and re-dock the iPhone.
This product is made for iPod, iPhone and iPad. To
prevent random interference when iPod, iPhone
and iPad is connected, the headphone output is
disabled, and "HP INVALID" will be displayed.
You may also experience brief audio interference during
incoming calls.
iPod, iPhone and iPad connection (USB only)
1
Insert the connector to the
iPod, iPhone or iPad.
2
Place the iPad to the stand
for iPad.
3
Connect the iPod, iPhone
or iPad to the unit via USB
connector.
Note:
USB terminal does not support VIDEO out.
iPod, iPhone or iPad playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the USB button on the remote control or FUNCTION button
repeatedly on the main unit to select USB function.
3
Connect iPod, iPhone or iPad to the unit. "USB/iPod" will appear.
4
Press the (CD/USB
Note:
Stop button ( ) is invalid during iPod, iPhone or iPad playback.
iPhone playback
Sound will only switch from iPhone to the main unit after
authentication process is completed in approximately 10 seconds.
Incoming calls will pause the playback.
Once the calls are answered, the conversation can only be heard
through the built-in iPhone speaker. Turn on the iPhone speaker or
undock the iPhone to start conversation.
iPod and iPhone connection (Dock only)
Note:
Docking station is not recommended for iPad connection.
XL-HF201P_HF301P_US.indd 6 XL-HF201P_HF301P_US.indd 6
iPad
Connector
iPad
Stand for iPad
USB
Track number
) button to start playback.
(continued)
Adaptor for iPod and iPhone connection
Notes:
Please use the adaptor supplied with your iPod or iPhone unit.
You can use an audio cable to connect your iPod to the AUDIO IN
jack if:
1. your iPod adaptor does not fi t into the iPod dock on the main
unit.
2. you have an iPod that does not have an iPod adaptor.
3. you have an iPod that does not have an iPod 30 pin connector.
Adaptor No. iPhone Description
12
iPhone
15
iPhone 3G
15
iPhone 3GS
19
iPhone 4
To insert adaptor for iPod or iPhone
1
Open the docking station for iPod and
iPhone by pulling up.
2
Insert the adaptor for iPod or iPhone into unit and connect your
iPod or iPhone.
iPhone (bottom)
Dock connector
Adaptor for iPhone
Dock for iPhone
Connector for iPhone
Caution:
Unplug all accessories from the iPod or iPhone before inserting it into
the dock.
To remove adaptor for iPod or iPhone
Insert the tip of a screwdriver ("-" type, small)
into the adaptor hole as shown and lift upward
to remove.

iPod or iPhone playback

1
Press the ON/STAND-BY button to turn the power on.
2
Press the iPod or iPhone button on the remote control or
button repeatedly on the main unit to select iPod function.
3
Insert iPod or iPhone unit into the dock of main unit. "DOCK OK"
will appear.
4
Press the (iPod or iPhone
E-6
Capacity
4GB & 8GB & 16GB
8GB & 16GB
16GB & 32GB
16GB & 32GB
iPhone
FUNCTION
) button to start playback.
3/7/2012 10:35:22 AM 3/7/2012 10:35:22 AM