HighPoint RAID Management Interface Manual page 7

HighPoint CLI Reference
Entering commands at the CLI prompt
Entering a string of a single commands on one command line
Using the CLI prompt:
You can enter commands at the main prompt and view the output on-screen.
To use the HighPoint CLI prompt, follow these steps:
1 Enter the following command at the shell prompt:
2 Enter the username and password to log on to the CLI.
Note: The default username is RAID and the default password is
hpt. You cannot change the password using CLI; to changed
password you must use the browser based utility.
After successfully logging in, the main prompt of the CLI will be
displayed:
Commands are entered at the CLI prompt. The CLI Command
Reference section discusses these commands in detail (see page 4).
Using a single command line
You can enter a complete command with parameters at the shell prompt and
receive one output result on the screen at a time.
Syntax
hptraidconf [-s adapter-id | -i server-address:port] –u {username} –p
{password} {command}
For RR1xxx, RR2xxx, and RR3xxx adapters without
out-of-band management:
# hptraidconf [-i server-address:port]
Here server-address:port specifies the network address and TCP
port of the RAID management service (hptsvr). By default,
localhost:7402 will be used.
For RR3xxx and RR4xxx adapters with out-of-band
management:
# hptraidconf [-s adapter-id]
Here adapter-id specifies the adapter to be managed (in case of
multiple adapters installed. By default, the first adapter (0) will
be used.
HighPoint CLI>
- 3 -