Set {Controller} Ce=[Y|N]; Set {Controller} Bp=[Y|N]; Set {Controller} Rp=[1-100]; Set {Controller} Sd=[Minutes] - HighPoint RAID Management Interface Manual

HighPoint CLI Reference
[88-100]
Example
HighPoint CLI> set RP=50
set {controller} AR=[y|n]
Set enable or disable to the [Auto Rebuild] parameter.
Example
HighPoint CLI> set AR=y

set {controller} CE=[y|n]

Set enable or disable to the [Continue Rebuilding On Error] parameter.
Example
HighPoint CLI> set CE=y

set {controller} BP=[y|n]

Set enable or disable beeper.
Example
HighPoint CLI> set BP=y

set {controller} SD=[minutes]

Set value of [Spindown Idle Disk]
Example
HighPoint CLI> set SD=10
Setting device parameters
Syntax: set {device id} tcq=[y|n] ncq=[y|n] wc=[y|n] ra=[y|n] smart=[y|n]
The options are:
tcq=[y|n]
Set enable or disable to the tcq parameter.
Highest
- 21 -