Advertisement
Start the instrument/Menu Setting
nstrument/Menu Setting
Start and shut off the meter
When off, press
key, instrument and laser get starting simultaneously and into stand by for measurement.
When already on, hold down
there has been no operation for 150 seconds.
Unit setting
Press the
key to reset current unit of measurement, the machine default unit is: 0.000m
Backlight Setting
Hold down the
key to turn the backlight on and off.
Optional units are available as below:
Length
0.000 m
0.00 m
0.0 in
0.00 ft
Measurement benchmark setting
Press
key to enter into setting of switching between front benchmark and end benchmark.
System usually takes end benchmark as default.
Measurement for distance, area, volume;
Pythagorean proposition indirect measurement, adding & subtracting
Single Measurement:
Press
key under measuring mode, the laser will be emitted, measuring location.
Re-press
key for single measurement of distance , then the measured results will show on main display.
Continuous Measurement:
Long press
key under measuring mode to enter into continuous measurement state, and maximum and minimum
measurement results in the process of continuous measurement will display on the screen.
The main display screen indicates the measured result, press
Area Measurement:
Press
key and you will see
following operations according to screen tips:
Press
key to measure the first edge(length).
Press
key to measure the second edge(width).
Area will be calculated automatically by the meter, and the results showed on main display screen.
Press
key to remove previous measured result and get ready for the next measurement.
Volumetric Measurement:
Double press
key and you will see
following operations according to tips:
Press
key to measure the first edge(length).
Press
key to measure the second edge(width).
Press
key to measure the third edge(height).
Volume will be calculated automatically by the meter, and the results showed on main display screen.
Press
key to remove previous measured result and get ready for the next measurement.
i
key for 3 seconds to turn the device off. The instrument will automatically shut off if
Area
0.000 m
2
0.00 m
2
0.00 ft
2
0.00 ft
2
on the display screen, that is Rectangle with one edge flashing. Complete the
, on the display screen, that is cube with one edge flashing. Complete the
Volume
0.000m
3
0.00 m
3
0.00 ft
3
0.00 ft
3
key to exit continuous measurement state.
Advertisement
