Trouble Shooting - Kogan KABRP21WFIA User Manual

Please check the following guide for the possible cause and solution for a problem before contacting the
nearest service center or dealer for repairs.
The following do not indicate a problem with this unit:
Regular disc rotating sounds.
Image disturbance during search.
To reset this unit
To return all settings other
than some settings to the
factory preset
POWER
No power.
The unit switches to standby
mode.
Operation
The remote control doesn't
work properly.
The unit is on but cannot be
operated.
Play fails to start even when
(PLAY) is pressed. Play starts
but then stops immediately.
Startup is slow.
When the unit is turned on,
audio and video output takes
a long time.
Select Yes in Restore Default Settings in the Setup menu.
This returns all values in the Setup menu and the on-screen
menu, except for parental setting to the default settings.
Insert the AC power supply cord securely into a known active AC outlet.
This is a power saving feature.
One of the unit's safety devices is activated. Press [STANDBY/ON]
on the main unit to turn the unit on.
The batteries are depleted. Replace them with new ones.
You are not pointing the remote control at the main unit's remote control
signal sensor during operation.
Colored glass may obstruct the signal reception/transmission.
Don't place the signal sensor in direct sunlight or in areas that may be
subject to sunlight exposure.
Confirm the correct drive is selected.
Some operations may be prohibited by the disc.
Reset the unit as follows:
1.Press [STANDBY/ON] on the main unit to switch the unit to standby.
If the unit doesn't switch to standby, Alternatively, disconnect the AC
power supply cord, wait one minute, then reconnect it.
2.Press [STANDBY/ON] on the main unit to switch it on. If the unit still
cannot be operated, consult the dealer.
Condensation has formed: Wait 1 to 2 hours for it to evaporate.
Insert the disc correctly with the label facing up.
The disc is dirty.
You tried to play a blank disc or unplayable disc on this unit.
Startup takes time in the following situations.
Immediately after a power failure or the AC power supply cord is
connected.
When the unit is connected with an HDMI cable.
22

TROUBLE SHOOTING