Knoll Eco-System CI6 Installation Instructions Manual page 8

8
Function
Version
Reset
Channel On
Channel Off
Mute
Un-mute
Mute All
Un-mute All
Volume Request
Volume Set
Volume All
Input Request
Input Set
Input Select All
All Channels On
All Channels Off
All Channels Vol up
All Channels Vol dn
Channel Vol up
Channel Vol down
Bass adjustment
Treble adjustment
Display treble
Display bass
Note1: Volume up or down requests increase or decrease volume level by 5
Note 2: Treble and bass commands use hexadecimal values 0-F, default (flat) is 8.
Also, it is best to leave about a ½ second between commands, as some integrators may miss
commands if they are entered too quickly.
All commands also send a message back to the terminal after they have been completed, so that
it is easy to keep track of the previous commands that were sent.
Some commands are read or write only and some are both – for example:
Note:
Mute All is a write only command and Version is a read only command.
Supported Command Messages
Function
Version
Reset
Channel On
Channel Off
Mute
Un-mute
Mute All
Un-mute All
Volume Request
Volume Set
Volume All
Input Set
Input Request
Input Select All
All Channels Off
All Channels On
Command
(vr?)
(rx)
(#on)
(#of)
(#mu)
(#um)
(amu)
(aum)
(#vl?)
(#vl$$)
(avl$$)
(#sl?)
(#sl$)
(asl$)
(aon)
(aof)
(avlu)
(avld)
(#vlu)
(#vld)
(#b$)
(#t$)
(#b?)
(#t?)
Command
(vr?)
(rx)
(#on)
(#of)
(#mu)
(#um)
(amu)
(aum)
(#vl?)
(#vl$$)
(avl$$)
(#sl$)
(#sl?)
(asl$)
(aof)
(aon)
Range Read/Write
none read only
none write only
1-6 write only
1-6 write only
1-6 write only
1-6 write only
none write only
none write only
1-6 read only
1-6 / 0-87 write only
0-87 write only
1-6 read only
1-6 / 1-7 write only
1-7 write only
none write only
none write only
none write only
none write only
1-6 write only
1-6 write only
1-6 / 0-F write only
1-6 / 0-F write only
1-6 read only
1-6 read only
Message
Version Number
"Resetting..."
"Zone # on"
"Zone # off"
"Zone # muted"
"Zone # unmuted"
"All channels muted"
"All channels un-muted"
"Zone # volume level = $$"
"Zone # volume level set"
"All volume levels successfully changed"
"Zone # input set"
"Zone # is currently using input channel $"
"All zones set to source $"
"All zones turned off"
"All zones turned on"
Remarks
1 second
Note 1
Note 1
Note 1
Note 1
Note 2
Note 2