Download Print this page

Knoll Eco-System GSZ44 Installation Instructions Manual

8 channel eco-system controller-amplifier

Advertisement

Quick Links

GSZ44

Advertisement

loading

Summary of Contents for Knoll Eco-System GSZ44

  • Page 1 GSZ44...
  • Page 2 1) Read these instructions. 2) Keep these instructions. 3) Read all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
  • Page 3 FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
  • Page 6 four Note: While most speaker manufacturers follow industry convention of using red terminals for positive connections and black terminals for negative, some manufacturers may vary from this configuration. To ensure proper phase connections, and optimal performance, consult the identification plate on our speaker terminals, or the speaker’s manual to verify polarity.
  • Page 7 Note: It is very important to use a top quality RJ45 8/8 crimper tool. We strongly suggest using a cat 5 / RJ45 electronic tester to verify the wire conductors. future use brown future use white/brown Infrared orange ground white/blue +12 vdc blue future use white/orange SDA green...
  • Page 8 Bass up Treble up When the whole system is installed and Bass down Treble down the GSZ44 is powered up each of the MR40 keypads will undergo a diagnostic MUTE Mute button Function select and eventually turn on to source 1 at a button very low level.
  • Page 9 To turn off the zone either push the keypad button labeled off or the off button on the RB8 remote control. To turn on the zone on either press the source button or the off button on the remote or keypad. If you press the OFF button the zone will go back to the source selected when it was last shut off.
  • Page 11 © Line level outputs give zone 1 Connect these RJ45 connectors to Connect the sources via the ability to connect to more MR40 Keypad. good quality gold RCA jacks powerful amplifiers Both are to inputs 1 through 4. volume & source controlled. Connect room Zone 1 Line Level...