Knoll CUT-IR Installation Instructions

CUT-IR Infrared Receiver Specifications:
Specifications
Infrared carrier frequency: 20-100kHz
Maximum wire length:
Wire requirements:
Dimensions:
Cord length
Requires 12VDC power supply, infrared receivers(s) and
connection block.
Warranty
Knoll Systems warrants its products sold in the USA and Canada by authorized
Knoll dealers to be free of defects in materials and workmanship. This warranty
extends for three full years from the date of purchase by the original consumer.
Any products returned to Knoll Systems and found to be defective by Knoll
Systems within the warranty period will be repaired or replaced at Knoll Systems
option, at no charge. Knoll Systems will not be responsible for the actual cost of
installation or removal of the product, nor for any incidental or consequential
damages. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you. This
warranty gives you specific legal rights. You may have additional legal rights
that vary from state-to-state.
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
14-7163 Vantage Way, Delta, BC V4G 1N1
Telephone: (604) 940-1689, Fax: (855) 734-3363
Made in Canada Knoll Systems All Rights Reserved
1000' (300m) or more with larger
gauge wire
2 conductors, minimum 24-gauge
to 200'; 22-gauge up to 500';
20-gauge to 1000'
1" x 1.5" (25mm x 38mm)
75" (2 meters)
CUT-IR
Cutable, Bendable, Blocking,
Blue Blinking Infrared Emitter
v1.0
Warning: To be installed and/or used in accordance with
appropriate electrical codes and regulations.
Introduction:
Thank you for your purchase of a Knoll CUT-
IR infrared emitter. This unique emitter is a blocking style (does
not permit other infrared signals to be read by the component
receiver) that can be cut (with scissors) to almost any size and
shape to become a non blocking emitter. The CUT-IR is
designed to be installed directly over the IR sensor window of
the controlled device. It is the only emitter on the market that
can be installed on non-flat surfaces, as it can bend around
uneven component surfaces. It also features a blue color
blinking talkback led to give visual confirmation that the infrared
remote signal is being rebroadcast to the component.
Features:
 Can be cut with scissors from an
infrared blocking emitter to non
blocking
 Can be bent to attach to non-flat
IR sensor windows.
 Blue color visable talkback led can
be covered with black tape to remove talkback
indication
 Industry standard yellow color 3.5mm plug jacket.