Jeep Patriot Owner's Manual page 209

29. Electronic Stability Control (ESC) Activation/
Malfunction Indicator Light — If Equipped
The "ESC Activation/Malfunction Indicator
Light" in the instrument cluster will come on
when the ignition switch is turned to the
ON/RUN position. It should go out with the
engine running. If the "ESC Activation/Malfunction In-
dicator Light" comes on continuously with the engine
running, a malfunction has been detected in the ESC
system. If this light remains on after several ignition
cycles, and the vehicle has been driven several miles
(kilometers) at speeds greater than 30 mph (48 km/h), see
your authorized dealer as soon as possible to have the
problem diagnosed and corrected.
NOTE:
The "ESC Off Indicator Light" and the "ESC
Activation/Malfunction Indicator Light" come on mo-
mentarily each time the ignition switch is turned to
ON/RUN.
UNDERSTANDING YOUR INSTRUMENT PANEL 207
Each time the ignition is turned to ON/RUN, the ESC
system will be ON, even if it was turned off previously.
The ESC system will make buzzing or clicking sounds
when it is active. This is normal; the sounds will stop
when ESC becomes inactive following the maneuver
that caused the ESC activation.
30. 4WD! Warning Light
This light monitors the 4-Wheel Drive (4WD)
system. The light will come on, for a bulb
check, when the ignition key is turned to the
ON/RUN position and may stay on for as long
as three seconds.
When lit solid: There is an 4WD system fault. 4WD
performance will be at a reduced level. Service the 4WD
system soon.
When blinking: The 4WD system is temporarily dis-
abled due to overload condition.
4