Turn Signal/Wiper/Washer/High Beam Lever - Jeep Grand Cherokee User Manual

OPERATING YOUR VEHICLE

TURN SIGNAL/WIPER/WASHER/HIGH BEAM LEVER

Turn Signal/Lane Change Assist
• Tap the lever up or down once and the turn signal (right or left) will flash three
times and automatically turn off.
Front Wipers
Intermittent, Low And High Operation
• Rotate the end of the lever to the first detent position for one of four intermittent
settings, the second detent for low wiper operation and the third detent for high
wiper operation.
Washer Operation
• Push inward on the end of the lever and hold for as long as spray is desired.
Mist
• Rotate the end of the lever downward when a single wipe is desired.
NOTE:
The mist feature does not activate the washer pump; therefore, no washer fluid will
be sprayed on the windshield. The wash function must be activated in order to spray
the windshield with washer fluid.
Rain Sensing Wipers
• This feature senses moisture on the vehicles windshield and automatically activates
the wipers for the driver when the switch is in the intermittent position. Rotate the end
of the lever to one of four settings to activate this feature and adjust sensitivity.
• This feature can be activated/deactivated using the Electronic Vehicle Information
Center (EVIC). Refer to the Programmable Features under the Electronics section in
this guide.
• Refer to the Owner's Manual on the DVD for further details.
30