Honda HS520A Owner's Manual page 4

3. Install the starter bracket using the hardware removed from step 2
on the previous page. For the HS520AS, snap the starter rope into
the rope guide on the handlebar and secure the electric start wire
using the two cable ties as shown. Trim the cable ties to a length of
3/8 inch (10 mm).
HS520A
FLANGE NUT
HS520AS
9 mm
CURVED
WASHER
FLANGE
NUT
ELECTRIC
STARTER
BRACKET
CABLE TIE (2)
4
CURVED
HEAD BOLT
STARTER
BRACKET
CURVED
HEAD BOLT
ROPE GUIDE
4. Install the discharge chute using the three 6 mm Phillips-head
screws and 6 mm self-locking nuts. Make sure the screws go on
the inside and the nuts on the outside. Tighten the nuts securely:
HEX NUT TORQUE: 7 ft-lbs (10 N•m)
PHILLIPS-HEAD
SCREW (3)
CHUTE BASE
PHILLIPS-HEAD
SCREW (3)
5. Lift the spark plug door and
attach the spark plug cap to
the spark plug.
6. Remove any packing material from the side of the snowthrower.
6 mm NUT (3)
CHUTE
CORRECTLY
ASSEMBLED
6 mm NUT (3)