HoMedics EnviraScape WFL-SLMP Instruction Manual And Warranty page 3

ASSEMBLY INSTRUCTIONS:
Item includes: Fig. 1
A-Three tiers with tubes
B-Platform
C-Fountain Base
D- River Rocks
E-Pump
F-Adaptor
1. Unpack the product from package carefully. Keep packaging mate-
rial for safe storage.
2. Familiarize yourself with the pump (E). The pump speed is controlled
by the switch located at the front of the pump. The speed (Fig. 4)
is indicated by a plus(+) and minus(-) sign. To increase the speed,
move the switch slowly in the direction of the plus sign. You will hear
a click as the switch moves to each speed level. At its highest speed
level, the switch will cease to move any further. To decrease the
pump speed, move the switch toward the minus sign. Similarly, at its
lowest speed, the switch will cease to move any further.
Note: It is recommended the pump be set at its highest speed dur-
ing assembly and later adjusted to a lower setting if desired. Be sure
to unplug the pump before adjusting the speed setting.
3. Insert the tube (located on the bottom of platform (B)) into the pump.
4. Insert tubes for each tier (A) the corresponding holes on the plat-
form (B) as shown in Fig. 1. Note: Please do not hold the tiers, hold
the tube under the tier instead for assembling.
5. Fill fountain (C) with water to 1" from top. We recommend using
distilled water to prevent mineral build up.
6. Set the platform with assembled tiers onto the base on top of the
notch so it sits level.
7. Attach the A/C adaptor jack (F) to the base power cord. DO NOT
plug into outlet at this time.
8. Set the fountain on a level, waterproof surface.
9. Plug the cord into 120V household outlet. The fountain is controlled
by the switch located on the power cord. If pump doesn't operate,
rotate in-line switch once to turn "on" and once more to turn "off".
Monthly maintenance will add to your pump's life.
Note: Ensure that the electrical cord loops below the electrical outlet
to form a 'Drip Loop' (Fig. 2). This will prevent water from running
down the cord into the electrical outlet.
10. Arrange the river rocks provided on the platform and/or tiers. (If
splashing occurs, rearrange rocks until there is no more splashing).
4
Figure 1
A. Tiers with
Tubes
Holes
ON/OFF
Switch
C. Fountain base
D. River
Rocks
B. Platform
E. Tube
Pump
Fill with water
Notch
Cord Slot
F. Adaptor
5