Activate tone menu Adjust bass Adjust treble Adjust balance Fader Loudness on /off Linear adjustment Adjust mono / stereo Radio Operation Select operating mode Select waveband Switch on radio menu mode Setting procedures for station selection FM, AM station search...
Page 3
USEnglisch.bk : Inhalt.fm5 Seite 3 Freitag, Februar 1, 2002 10:33 AM CD/MD Changer Operation Compact Disc (CD) instructions Operational readiness of CD/MD changer CD magazine - load / unload Playing CD/MDs Track skip - forwards / reverse Scan search Fast forward / rewind Relative time, number of tracks, total playing time 22 Random play Direct track selection...
USEnglisch.bk : DIEB.fm Seite 5 Freitag, Februar 1, 2002 10:33 AM Code number entry If the car radio is disconnected from the power supply, it is theft-protected upon reconnection. After switching on at the followed by 4 stars is displayed. The four-digit code must then be entered using the multifunction buttons “1-0”.
USEnglisch.bk : DIEB.fm Seite 6 Freitag, Februar 1, 2002 10:33 AM Anti-theft Device Remove portable panel As an effective anti-theft device, the portable panel (A) can be removed from the unit. For this purpose, press and hold button. The display folds forwards. The portable component can then be pulled out.
The tone menu is activated. The following functions can be called up: BASS (Bass), TREB (Treble), BAL (Balance), FAD (Fader), LOUD (Loudness) and STEREO (Reception optimization). Bass and treble settings for the AM/FM wavebands, for road traffic announcements and tape/CD operation are stored separately (values from -7 to +7).
USEnglisch.bk : Allgemeine.fm Seite 8 Freitag, Februar 1, 2002 10:33 AM General Operation Adjust bass Press button and then multifunction button “-” or “+”. BASS and the set value are displayed. Set the desired bass via both buttons. Center setting: Press both buttons simultaneously. Adjust treble Press button and then multifunction button “-”...
Repeatedly press multifunction button “ST” in tone menu until the desired optimisation is set. AUTO: Setting for normal operation - i.e., the unit switches from stereo to mono and back depending upon reception location (provides the optimum setting for almost all reception areas).
USEnglisch.bk : RUNDFUNK.fm Seite 10 Freitag, Februar 1, 2002 10:33 AM Select operating mode Press button. The operating modes Radio, TAPE or CD/MD changer (for connected CD/MD changer) can be selected. The last selected operating mode is selected after the button is pressed for the first time.
USEnglisch.bk : RUNDFUNK.fm Seite 11 Freitag, Februar 1, 2002 10:33 AM Radio Operation Setting procedures for station selection The desired broadcasting station can be selected via station search, scan search, manual tuning, autostore, direct frequency input and station buttons. FM, AM station search Turn the right rotary control to the left/right in desired waveband.
USEnglisch.bk : RUNDFUNK.fm Seite 12 Freitag, Februar 1, 2002 10:33 AM Program type display/search (PTY) Select radio menu mode and then and press multifunction button “PT”. The selected station program type is displayed for 10 seconds (e.g. SOFT RCK = soft rock).
USEnglisch.bk : RUNDFUNK.fm Seite 13 Freitag, Februar 1, 2002 10:33 AM Radio Operation AM station - retrieve/store Retrieve: Press multifunction button “1 - 0”. The stored station is requested. Store: 10 stations can be stored under station buttons. Search for the desired station and press the multifunction button until the station button number is displayed.
USEnglisch.bk : RUNDFUNK.fm Seite 14 Freitag, Februar 1, 2002 10:33 AM Traffic Program (TP) The traffic program system offers the advantage that current traffic news can be received and heard despite the fact that Tape or CD/MDC are selected. For this purpose, it is essential that a traffic program station is selected in the FM waveband and that the traffic program is activated.
USEnglisch.bk : RUNDFUNK.fm Seite 15 Freitag, Februar 1, 2002 10:33 AM Radio Operation Telephone mute function The telephone characteristics can be set in the user menu (see also page 25) if a telephone system is installed in the vehicle and the mute function lead for the car telephone is connected to the car radio.
USEnglisch.bk : CC.fm Seite 16 Freitag, Februar 1, 2002 10:33 AM Cassettes - insert / eject Press button briefly; the display folds downwards and the cassette slot becomes visible. Push in cassette with tape-side to the right until it engages and press lightly.
USEnglisch.bk : CC.fm Seite 17 Freitag, Februar 1, 2002 10:33 AM Tape Operaiton Fast forward / rewind During cassette operation, fast forward / rewind can be activated using the multifunction buttons. In order to cancel the function, press or turn the right rotary control, or press the track switching buttons or the fast forward / rewind buttons.
USEnglisch.bk : CC.fm Seite 18 Freitag, Februar 1, 2002 10:33 AM Skip blank If skip blank is active, automatic forward is activated at blank tape sections which are longer than 10 to 15 seconds. In order to activate the function, press the multifunction button “SB” until SB is shown on the display.
USEnglisch.bk : CD.fm Seite 19 Freitag, Februar 1, 2002 10:33 AM Compact Disc (CD) instructions Sound interruptions may occur if the CD is soiled. In order to ensure optimum tone quality, please note the following: Always touch the CD at the edges only. Keep the CD clean and never touch the surface.
USEnglisch.bk : CD.fm Seite 20 Freitag, Februar 1, 2002 10:33 AM CD/MD Changer Operation CD magazine - load / unload In order to remove the CD magazine, open the sliding cover on the changer and press the eject button. The magazine is ejected and can be removed. When inserting CDs in the magazine, please note imprint on magazine.
USEnglisch.bk : CD.fm Seite 21 Freitag, Februar 1, 2002 10:33 AM Track skip - forwards / reverse Turn right rotary control to right / left. If the track has been playing for longer than 10 seconds when the return function is triggered, a return to the beginning of the track takes place. Through further turning of the right rotary control, several tracks can be skipped over in forward or reverse directions.
USEnglisch.bk : CD.fm Seite 22 Freitag, Februar 1, 2002 10:33 AM CD/MD Changer Operation Relative time, number of tracks, total playing time Press button after which by pressing the multifunction button “T”, the relative time for the track currently being played is displayed for approx. 10 seconds.
USEnglisch.bk : USER.fm Seite 23 Freitag, Februar 1, 2002 10:33 AM User menu - request / quit After requesting the user menu, the following basic settings can be entered according to your personal preference. USER user memory SEEK search mode speed dependent volume control DRIVER LHD / RHD setting...
USEnglisch.bk : USER.fm Seite 24 Freitag, Februar 1, 2002 10:33 AM User Menu User memory Request user menu, then set USER using the right rotary control. Using the multifunction buttons “ ” or “ ” a choice of three different users is available. Both tone settings and the last selected station as the unit was switched off are stored in each user memory.
USEnglisch.bk : USER.fm Seite 25 Freitag, Februar 1, 2002 10:33 AM Telephone mute characteristics (PHONE) If a telephone system with handsfree unit is installed in the vehicle, the telephone conversation can be conducted via the car radio system. Thus, installation of the normally required additional loudspeaker is not necessary. However, the signal cables (AF - telephone input and earth - telephone input) must be connected to the car radio (see page 29).
USEnglisch.bk : USER.fm Seite 26 Freitag, Februar 1, 2002 10:33 AM User Menu Country setting (COUNTRY) Various countries can be set using this function, i.e. the search steps or the received waveband are changed according to the selected setting. Request user menu, then set COUNTRY using the right rotary control. Choose one of the settings listed below using the multifunction buttons “...
USEnglisch.bk : Anschluss.fm Seite 27 Freitag, Februar 1, 2002 10:33 AM Socket A Speed-dependent volume control not assigned Telephone mute / clearing function Permanent positive (terminal 30) Control output for automatic aerial / amplifier not assigned Switched positive (terminal 15) Earth (terminal 31) Socket B Loudspeaker rear right +...
USEnglisch.bk : Erläuterung.fm Seite 28 Freitag, Februar 1, 2002 10:33 AM General Instructions RBDS system This car radio is capable of receiving RBDS signals (RBDS = Radio - Broadcasting - Data - System) in the FM range. RBDS is a technique which enables the transmission of inaudible additional information in the FM broadcasting range.