Advertisement
Quick Links
Download this manual
See also:
Manual
PRODUCT FIRMWARE UPDATE:
HD HERO2, Wi-Fi BacPac™ and
Wi-Fi Remote
BEFORE YOU GET STARTED:
• Make sure your HD HERO2, Wi-Fi BacPac™ and Wi-Fi Remote are
Update process.
• Make sure your HD HERO2 has an SD card inserted (Format your SD card using your HD
HERO2 camera, and take at least one test photo or video before attempting the Update process).
• Remove any accesories (such as the LCD BacPac™ or Battery BacPac™) from your
HD HERO2 camera.
• Make sure your GoPro CineForm Studio software is current:
• Make sure your computer has an active connection to the internet.
UPDATE YOUR HD HERO2:
1) Without any BacPac™ accessories connected, power ON your HD HERO2 camera and connect
it to your computer via USB.
2) Launch GoPro CineForm Studio, and an 'Update Available' notice will appear.
3) Press the 'SHOW DETAILS' button, and this will launch the Device Window.
4) Select your HD HERO2 camera from the list, and press 'UPDATE'.
5) Wait for the Update process to complete (camera may beep and lights will flash), and when
process finishes you may disconnect and power OFF your HD HERO2 camera.
Note: Mac users may be required to follow additional steps to complete the Update process. Fol-
low the steps on screen to complete the firmware update of your HD HERO2 camera.
* To verify that your camera has been updated, power the camera ON, then reconnect camera
via USB to your computer. Once the device is recognized, the Device Window should display HD
HERO2 Version is Up to date.
fully charged
before attempting
cineform.com/downloads.aspx
Advertisement
Related Manuals for GoPro CineForm Studio
Summary of Contents for GoPro CineForm Studio
- Page 1 1) Without any BacPac™ accessories connected, power ON your HD HERO2 camera and connect it to your computer via USB. 2) Launch GoPro CineForm Studio, and an ‘Update Available’ notice will appear. 3) Press the ‘SHOW DETAILS’ button, and this will launch the Device Window.
- Page 2 (REQUIRED) REGISTER YOUR Wi-Fi BacPac™: Power ON your HD HERO2 camera and connect your Wi-Fi BacPac™ to the back of your camera (with both the camera and Wi-Fi BacPac™ powered ON). At this point, you should also power ON your Wi-Fi Remote. Make sure your Wi-Fi Remote is not connected to USB power through the USB charging cable.
- Page 3 • Do not leave your Wi-Fi Remote plugged in to USB power while attempting to update (remote should be fully charged before starting the update process). • If your GoPro devices are not recognized in the Device Window at any time, please try the following: 1) Press the Refresh button at bottom left of Device Window.