Goldmund MIMESIS 20M User Manual page 8

The RS 232 Db9 connector available on the power supply module on the
back panel of the Mimesis 20M is used to link the Mimesis 20M to external
units in order to control their function in remote or modify the built-in software.
It may be used to control the Mimesis 20M with remote systems like Phast or
Crestron.
1.5. FRONT PANEL KEYBOARD FUNCTIONS
- Standby function :
The Standby position can be activated by pressing the front panel key
marked "SET/PWR" first, then without releasing it, the "DOWN/PWR" key. A
repetition of the same operation brings back the unit to normal functioning.
When the machine is in standby the front panel Led controls are off except
the red "SBY" Led, but the circuitry remains connected as long as the power
supply switch is not turned off.
- Input Source Selection :
The back panel inputs are selected by pressing the front panel keys marked
from "CH1" to "CH7".
When only one of these keys is pressed, the corresponding source is
selected and transmitted to the converter circuitry. The corresponding green
Led indicates this selection.
If a source is connected, the unit will first analyze the signal and finally turn
the unit on to listen to that source.
The delay before connecting the output is needed to perfectly stabilize the
circuits if the source selected has a different clock frequency than the
previous selected one and avoid any annoying noise.
- Recording Source Selection :
Any source can be selected to be recorded independently from the source
that is played (it can be the same or a different one).
To select the source that will be recorded, first press once the "REC/MENU"
key, then press the channel key you want to select. If no source is selected,
the unit returns to normal function after 4 to 5 seconds.
The corresponding red light will glow, showing which channel is selected.
The selected source will be sent to both digital outputs of the machine.
However, if the corresponding source has been chosen in the Menu as a tape
machine, this machine output will not be connected to avoid noise loop.
P7
User manual – Goldmund MIMESIS 20M D/A CONVERTER