Extended Firmware Settings - Qlogic QLA22xx board Installation Manual

A – Fast!UTIL
Disable Database Load. When enabled, the device database is read from
the Registry during driver initialization. When disabled, the device database
is created dynamically during driver initialization. The default is No.
NOTE: This option usually applies to Windows NT operating environment.
IOCB Allocation. This setting specifies the maximum number of buffers
from the firmware's buffer pool that are allocated to any one port. The default
is 256 buffers.
Extended Error Logging. This setting provides additional error and debug
information to the operating system. When enabled, events are logged into
the Windows NT Event Viewer. The default is Disabled.
A.2.6

Extended Firmware Settings

From the Configuration Settings menu in Fast!UTIL, select Extended Firmware
Settings. The default settings for the QLA22xx host adapter board are listed in
table A-3 and described in the following paragraphs.
Setting
Extended Control Block
RIO Operation Mode
Connection Options
Class 2 Service
ACK0
Fibre Channel Tape Support
Fibre Channel Confirm
Command Reference Number
Read Transfer Ready
Response Timer
Interrupt Delay Timer
FC0151103-00 E
Table A-3. Extended Firmware Settings
Options
Enabled or Disabled
0, 1, 2, 3, 4
0, 1, 2, 3
Enabled or Disabled
Enabled or Disabled
Enabled or Disabled
Enabled or Disabled
Enabled or Disabled
Enabled or Disabled
0-255
0-255
Configuration Settings
Default
Enabled
0
3
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
0
0
A-5