Special Features; Handle Adjustments - Pullman Holt UV9 Operation & Care Instructions Manual

Special Features:

ON/OFF Switch:
This Pullman-Holt vacuum is equipped with a convenient handle
slide switch to turn power ON and OFF.
Automatic Self-Adjusting Carpet Nozzle:
This Pullman-Holt vacuum can fl oat evenly over varying carpet
pile lengths. The carpet nozzle height self-adjusts instantly and
automatically.
Full Bag Indicator Light:
A warning light located on the front of the switch cover below the
easy carry handle will activate when the dust bag is full, or if the
vacuum cleaner is clogged. Replace bag if full. To check for clogs,
unplug vacuum cleaner and inspect agitator area (see "Removing
the bottom plate") hose and attachment inlet.
Special Note: When cleaning with attachments, disregard the
full bag indicator light. Normal airfl ow restrictions occur with
attachment cleaning and may trigger a false signal.
When turning on the vacuum cleaner while the full bag indicator
light is on, and the vacuum cleaner will not start, check to see if the
dust bag is installed correctly.
Metal Collecting Device:
A magnetic metal collecting device is attached in the accessory
attachment opening. The metal collecting device prevents most
screws, needles, and other small metal parts from entering the
main body of the vacuum cleaner when the lid for the cleaning
attachment is closed. This will minimize the risk of damaging
internal components or the dust bag. The convenient location of
the collecting device provides easy access for removing collected
metal parts.

Handle Adjustments:

The handle of this vacuum cleaner can be set to any of three
positions: Upright, Middle, or Low. To release the handle, step on
the pedal at the left rear corner of the vacuum cleaner.
1. Upright position: Handle locks in this position for vacuum
cleaner storage. The handle should always be in the upright
position when cleaning tools are used.
2. Middle position: This position is for normal cleaning. While in
the middle position, the front of the nozzle can be raised by
lowering the handle in order to cross room thresholds.
3. Low position: This position is used for cleaning under most
furniture.
CAUTION
Be sure the building voltage is the same as the voltage on the
motor head nameplate and that a proper ground exists
On-Board Cleaning Tools:
This Pullman-Holt vacuum is equipped with state-of-the-art, on-
board cleaning tools including:
• Three-piece telescopic wand
• Crevice tool
• Dusting brush
• Upholstery tool
To use:
1. Remove hose cuff from nozzle inlet.
2. Connect hose cuff to three-piece telescopic wand. Unlock
wand collar to extend wand to desired length.
3. Attach selected cleaning tool to wand. (Tools may also be at-
tached directly to fl exible hose cuff, omitting extension wand.)
4. Cleaning tools are stored conveniently on back of the vacuum
cleaner body. Snap tools back into their appropriate places.
Connecting the Tools:
Connect any of the cleaning tools to the extension wand or curved
wand and twist for secure fi t.
Connecting the Optional Hose Assembly:
Simply lift the lid of the cleaning attachment opening located at
the back of the vacuum cleaner and insert the hose end until it
fi ts snugly.