Typical Control Panel; Earphone Jack; Sleep Timer (Some Models) - Zenith SENTRY 2 SM0953X Operating Manual & Warranty

Sentry 2 series monaural color tv
Table of Contents

Advertisement

GETTING TO KNOW YOUR TV
TYPICAL
CONTROL
PANEL
The control panel on your TV may differ from the one
shown.
NOTE: Some TVs have a vertical control panel - the
operation is the same as described for the control panels
shown above.
ENTER (ENT)
Press to see the Channel/Time dis-
play, or to remove any on-screen
display or menu.
SELECT (SEL)
Press during on-screen menu
operations
to select a menu op-
tion.
VOLUME (VOL) Up/Down
Press to increase or decrease
the sound level.
OFF-ON
Press to turn TV
power ON or OFF.
ENTER
•ADJUST•
SELECT
CHANNEL A
OFF-ON
ADJUST (ADJ) Left/Right
Press during on-screen menu
operation to see information!status
display for selected option. Press
again to adjust the selected menu
option.
MENU
Press once to see a menu. Press
repeatedly to sequence through
the available menus.
CHANNEL (CH) Up/Down
Press to select channels higher
or lower than the channels being
viewed. You can add channels to
or delete channels from the scan-
ning sequence stored in memory
of the TV. See CH. ADD/DEL
option for channel programming
information.
Remote Window
Point the remote
control towards
this window to
operate the TV.
EARPHONE
JACK
The earphone jack is used to connect a private listening ear-
phone (optional item) to your TV set. When the earphone
is plugged in, the TV speaker is turned off. This permits you
to enjoy TV programs without disturbing others in the area.
Any earphone having an 8-ohm impedance and terminated
in a 3.bmm (1/8") subminiature
plug may be used.
CAUTION: When using the earphone, we suggest that you
set the volume on the TV to a low level before putting the
earphone in your ear. Then adjust the volume to a comfort-
able listening level.
SLEEP TIMER
(SOME
MODELS)
Some remote controls are equipped with a TIMER button
that provides access to the SLEEP TIMER available with
some TV models. By using the SLEEP TIMER, you can
program the TV to automatically shut off after a period
from 15 minutes up to 4 hours.
To Set SLEEP TIMER
1. Press TIMER
to see status
display.
2. Press
TIMER
repeatedly
until
you reach
desired
shut-off
time.
One minute before the TV shuts off, the GOOD NIGHT
display appears on the screen. At this time you have a
choice of the following three actions.
1. Do nothing.
The TV will shut off in one minute.
2. Remove
the GOOD
NIGHT
display
by pressing
ENTER (ENT). The TV will still shut off in one minute.
3. Delay the shut off by using TIMER
to select a new
shut off time.
To Cancel the SLEEP TIMER
You can cancel the SLEEP TIMER by setting the SLEEP
TIMER status to OFF. Press TIMER repeatedly
until OFF
is selected.
NOTE: The SLEEP TIMER resets to OFF when you turn
off the TV.
SLEEP TIMER
0:15
PRESS TIMER
KEY TO CHANGE
GOOD NIGHT
Sleep Timer Display
"Good Night" Display
z_o
4 -- 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sentry 2 sm0941x

Table of Contents