Equipment Codes 9 - Zenith Z27H96 Operating Manual & Warranty

!!NSTALL_THE:BA TEERIES
Ins._all 3 AA bat_'ries, matcliing + with + (positive with
p0sifive)i _d- with -.(negative with negative),' as Shown in
the battery compartment.
PROGRAMMING CABLE, VCR. AND AUX MODES
Follow these steps for each piece of equipment:
1. Locate the 3-digit code for your brand (such as
Zenith) and type of equipment (such as VCR) in the
"Equipment Codes" list on the following pages. -
2. Press PRG; remote displays PROGRAM.
3. Press VCR, CABLE, or AUX to select the piece of
equipment you want your remote to control. (Use
CABLE or AUX to program your remote for a
second VCR or Cable Box. Use AUX, to program
your remote for a video disc player or audio
equipment.)
4. Enter the three-digit code for your equipment, "
then press ENTER.
If valid, Remote displays "OK."
If invalid, Remote displays "ERR: ENTRY."
5. Press POWER repeatedly to verify that your
equipment turns On and Off. If none of the brand
codes works, try the Auto Find Option.
Notes:
• If you do not press arty key on your remote within 30
seconds, the programming process stops and you will have
to start again.
• You may cancel progr_ta-tming mode at any time by
pressing CANCEL, or Dywaiting 30 seconds.
• The TV mode is not l?rogrammable.
• Code 911 will erase all clock settings and delete all brand
and special features.
• If no code [s-programm_into the VCR, CABLE, or AUX
modes and that mode key is pressed, you will see the "Err:
Setup ° message. Pr0grama code(s) to use the VCR,
CABLE, or AUX modes.
AUTO FIND OPTION
If none of the codes listed in the table operates your equipment, you can use Auto Find to search fi3rthe code 3_0uneed.
Follow these steps for each piece of equipment you are usirig:
1. Turn the equipment On and point the remote
toward it.
2. Press PRG with a small blunt object, like a pen.
3. Press the key on the remote for the piece of
eqmpment you want to control: VCR, CABLE, or
AUX:
. - . . . . -.
4. Enter 0-0-0, then press ENTER w'ithin 2 Seco-xidsi
Auto Find is active when AUTO appears in display.
5. Press and hold POWER, then release it,repeating
this action about once a second until the product
turns OFF .....
6. Press ENTER immediately to save the code. If your
remote fails to operate the functions you use most
often, re-enter Auto Find and search for a better
code. - -
Notes:
• Press cANCEL at _ay' time during the use of Auto Find to
cancel AutoFind.
. 1
• If the display reads END when you press POWER, Auto
Find has triedall available Codes. If you finish Auto Find
and the equipment does not turn Off, your remote will not
work with "thatpiece of equipment.
CABLE BOxVOLUME MUTING
Cable!Volume Muting(Code 399)-._ '_- " "
Your remote cancontrol cable box volumeandmuting if
available onyourequipment. First, progr_ yourremote using ,:
theCABLE key. Thenrepeat _he programming steps, again
using the CABLE key,but enter 399.
. '7 .. , . . .,''.',:. . :
To restore TV -volume/mu_:eto the CABLE mode, simply
re-enter your cable brand code into that mode. , . .. ,.
%