Table of Contents
Advertisement
REMOTE CONTROL MODEL MBR3420
PROGRAMMING
BRAND CODES
Introduction
Before using your new remote control, it must be programmed
to recognize the brands of equipment it will be used to oper-
ate. If you are using a Zenith VHS VCR or a Zenith cable-TV
decoder, the remote has already been programmed for you.
Fiind the code that corresponds to each brand and type of
equipment you are going to operate. Refer to Tables 1, 2 and 3.
For example, if you were programming the remote for use
with a Zenith TV, you would look for "Zenith" in "Table 1",
and find code "101."
Write the brand codes for your equipment on the following
lines.
TV CODE:
CABLE
CODE:
VCRCODE:
1. Press MODE repeatedly
to select the desired TV, VCR
or CABLE operating
mode for the remote.
2. Press LEARN
for about 5 seconds
until the MODE
indicator
lights for the selected
TV, VCR or CABLE
mode of operation.
3. Enter the proper brand code number for the equipment
to be controlled.
4. Press LEARN. All three mode indicators
should light
briefly,
then turn off to indicate
the brand code has
been programmed.
5. If all three mode indicators
fail to light briefly,
an
error has occurred.
Repeat Steps 1-4 to try again.
6. Repeat steps 1-4 to program
the remote for the other
equipment
you are using.
NOTE:
CABLE mode can be programmed to operate a sec-
ond TV or second VCR, if desired.
When batteries are removed: It will be necessary to reprogram
the proper VCR and cable-TV decoder codes.
Operating Mode
Indicators
Numbered
Buttons
Use to enter code number
for desired brand.
LEARN Button
SELECT
®®®
®®®
®®@
LEARN
A
B
CHANNEL
VOLUME
MUTE
MEMORY
TIMER
SEQ
C_
CI:)
Ci]:)
C_)
RECORD
STOP
PAUSE
SEARCH
REW
PLAY
F FWD
"_/NCR
I
I
Operating MODE Selector
rT_-o
6 _
6
Advertisement
Table of Contents
