Installing Under-Cabinet Bracket - Zenith SENTRY 2 SAR2035Y7 Operating Manual & Warranty

INSTALLING UNDER-CABINET BRACKET (Select MOdels)
Front of
Bracket
-7
5-Phillips Head Screws
5-Plaetlc Finish Washers
I I--m'-I
I I
" ,__--_---- Cabinet Bottom Surface
5-Spacera if Needed
5.Threaded Nuts
Point A, Swivel Bracket Handle
2-Hex-head Screws
Swivel Bracket Up Tabs
13/Back Top Surface
4_-- 1-3/4"----_
When 13/Is Mounted on Bracket,
Minimum Clearance Should Be
1-3/4 inches Between "IV and Wall.
Note: See page 3-I for AC or DC cord
storage.
Step 1. (Before Under-cabinet Installation)
Use the 2 Hex-head screws supplied to attach the bracket
handle to the bracket swivel. Use a !/4 inch hex-head nut
driver.
Step 2.
Insertthe swivelbracket lip into the top recess of the "IV
cabinetonly untilthe lip tabs snap and lock into position.
(Point "A" of the swivelbracket handle mustbe in positive
contactwith the TV's back top surface.)
Place the TV with the bracketattached in the desired loca-
tion.
Note: Be_sureyou have at least 1-3/4 inches of clearance
to the wall, or other surface if there is one, behind the
back of the TV to allow enough clearance to Install and
remove the TV from the swivel bracket when required.
Using a graphite pencil, mark a thin line along the back,
right and left side edges at the top of the bracket where it
meets the cabinet mounting surface. Use this pencil line as
a guide for positioning the swivel bracket template used for
drilling the 5 holes that will be used to secure the bracket
into position. Use a center punch or other sharp instrument
to make indents or marks to be used for drilling into the
under-cabinet surface; use a drill bit at least 3/16 inches in
diameter. (Do this for all the holes and check each one for
accuracy, all holes must align with the drilling template.)
Remove the bracket from the TV set
bylifting
the bracket
handle up only far enough until it snaps out of position and
slide it out from the TV.
Attach the swivel bracket to the under-cabinet surface. In-
stall the appropriate length threaded screws, plastic finish
washers and threaded nuts for each of the 5 holes you
drilled that were marked with the template.
Note: If your kitchen cabinet has a long bottom skirt then
you may need to use the extra spacers provided so that
the bracket and "IV will be located far enough below the
cabinet for viewing.
Step 3. (After Under-cabinet Installation)
Once the bracket is mounted and secured to the under-
cabinet surface, attach the TV set to the bracket by sliding
the "IV cabinet over the bracket lip as before until the TV
snaps into its secured position. Shift the left/right angle of
the 'IV to the desired viewing position.
To remove TV from bracket, securely hold TV, lift.swivel
bracket handle up high enough to allow the TV to be
released from the lip tabs, slide TV away from bracket.
Step 4, (After Under-cabinet Installation)
Be sure to avoid installing the AC or DC cords near any
heating elements or cooking appliances. An AC]DC cord
purse-lock retainer is provided for storing the cord that is
not in use. (See page 3-1)
2_-o 1 -- 1