Advertisement
Automadc
lce and Water Dispenser
PureSource
TM
* Ice and Water Filter
(come
models)
NOTE:If yo, p.rc.ased a refrigerator withaP.reSe.roe *
and water i ter, p laase r ead thefollowing .se
and care information.
This ice and wate_ filter system
filters water
to your ice maker and water
dispenser,
It is
located
in the upper
right back corner of the fresh food compartment,
System Startup:
Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter
cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section
to properly fill the system with water.
Changing
the Filter:
Order new filter cartridges
through the
dealer where you bought the refrigerator,
contact the Consumer Assistance Center
at 1-800@44-9044, or go to our web site
at www.friqidaire.com,
it might be good
to order some filter cartridges when you
first install your refrigerator. Be sure to ask
for
the
RG-100
PureSource
TM*
replacement
cartridge.
The PureSource
TM
* NGRG-
2000
ice and Water
Filter
System
with
the
RG-100
cartridge
is
tested
and
certified by NSF international,
the nationally
recognized
and respected,
not for profit, certification
organization
for
public health safety. The PureSoume TM*
system is tested and certified to ANSI/NSF
Standard 42. See performance
data sheet
for specifications.
This system should not
be used on water that is microbiologica!Iy
unsafe or with water of unknown
quality
unless the water
has been adequately
disinfected before or after traveling through
the filtration system.
Rated Capacity - 400 gallons
Rated service flow - .5 GPM
Maximum Rated Pressure _ 100 PSi
Maximum Operating Temp. - 100 ° F
Water conditions
vary throughout
the world, but changing
the water filter every
6 - 9 months
normally wiii ensure the highest possible water quality. The Filter
Status light wiii turn red after 400 gallons of water
has flowed through
the ice
and water dispenser
(some models). Also, if the filter has been in a refrigerator
that has not been in use for awhile (during moving
for example),
change
the
filter before reinstalling
the refrigerator.
The dispenser
system wiii also operate
without
filtration
(with filter cartridge
removed).
To change
filter:
It is not necessary
to turn the water supply off to change
the filter=
1,
Open freezer door and leave open until filter change
is complete=
2,
Set ice maker wire signal arm to the OFF (up) position
(See illustration
on
page 13).
3.
Hold filter cup firmly, and unscrew towards
left (Some water could
leak out as you remove cup. This is normal.).
Filter cartridge
should come
down with cup. if cartridge
remains
in housing,
pull down gently, while
twisting
filter back and forth.
4.
Rinse out cup under running water.
5.
The large o-ring that seals the filter system
sets in the o-ring groove
down inside the cup. Should the o-ring fall out during filter cartridge
replacement,
simply place it back in the groove
prior to screwing
the cup
back in place,
if the o-ring becomes
damaged,
you will need to order one
from the Consumer
Assistance
Center.
6.
Discard old filter cartridge.
7.
Remove new filter cartridge
from packaging
and place in cup. The end
with the small o-ring should
be up, out of the cup.
8.
Screw cup, with filter, back onto housing. Do Not Use Wrench
To Reinstall
Cup. Filter cartridge
will self-align
as cup is tightened.
Be sure cup is
compbtely
tightened
with PureSeurce
TM
logo facing outward.
Do Not
Tighten
Past Stop,
9.
Set ice maker wire signal arm to the ON (down)
position.
10. Check for leaks. Open refrigerator
door. Wipe any water droplets
from the
filter cup. Fill a glass with water, if there is a leak, unscrew filter cup, and
reinsert the filter cartridge.
Check placement
of large O-ring.
Reinstall
filter cup, making certain
it is tightened
completely.
1. To condition
filter system and purge air from water line, fill a glass with
water. Continue
flushing
the system for approximately
3 minutes to assure
that the purest water possible
is stored in the water
tank.
iMPORTANT; ResettingThe
Fiffer status Light (SOme model@
After
replacing the filter cartridge, it wiii be necessary to press the Filter
Status
reset button located on the ice and water dispenser, This will reset
!ights
flash (t0:15
Seconds), Please
refer to the comp!ete dispenser
Reminder
Stickers included
in the envelope
that the Use & Care
Manual
came in. Choose
a dated sticker that indicates
6 - 9 months
(depending
on your water qua!ity
and usage)from
the date of installation.
Place the
change the filter,
* White Westinghouse
uses the name CrystaIClear
instead of PureSource,
but they are the same filter
15
Advertisement
