Dishwasher - Whirlpool DU920PFGB4 Use And Care Manual

4. Place a shallow panunder thewater
supply valve.Then,usea wrench to
disconnect thewaterinletfromthe
watersupply valve.Separate t hewater
inletfromthewatersupply valveand
drainwaterintothepan.
5. Remove the spring clamp from the
water outlet and separate from the
water supply valve; drain water into
pan.
6. Reconnect both water inlet and water
outlet to the water supply valve.
7. Empty the pan and reposition it under
the water pump.
8. Remove the clamp and disconnect the
drain hose from the water pump; drain
water into pan.
9. Reconnect drain hose to the water
pump, being sure to position the clamp
over the connection.
10. Replace the lower access panel.
NOTE: If your dishwasher is connected to
a garbage disposal, do not run water into
the sink after winterizing. This could cause
water to refill the drain hose on your
dishwasher.
Reconnecting your dishwasher
1. Remove the 4 screws on the lower
access panel and remove lower
access panel.
2. Turn on the water supply to dishwasher.
3. Reconnect power or plug in dishwasher.
4. Run dishwasher through a complete
cycle and check for leaks.
5. Replace lower access panel.
Built-in models
Spring Water pump
ater outlet clamps and motor
Water supply Water Drain
valve inlet hose
Portable models
Spring Screw Water pump
Water outlet clamp clamp and motor
i ii
Water supply Water inset
valve
.....
Drain hose
27