Table of Contents
Advertisement
SWING OPERATION
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 5 O).
The SWING Display (Fig. 6 [) will light.
Each time the SWING button is pressed, the swing operation will change in the
following order.
Up/down swing operation
Swing operation stops
To stop SWING Operation
Press the SWING button and select STOP.
AirÀ ow direction will return to the setting before swing was begun.
About Swing Operation
● Up/down swing: Swing operation begins using the following
range according to the current airÀ ow direction.
AirÀ ow direction is 1–4 (for cooling, dry).
With the upper airÀ ow-direction louver in the horizon-
tal position, the lower airÀ ow-direction louver moves
(swings) to direct airÀ ow to a wide area.
● Left/right swing: The airÀ ow-direction louvers move (swing)
in the left/right airÀ ow direction.
ECONOMY OPERATION
Begin Air Conditioner operation before performing this procedure.
To Use the ECONOMY Operation
Press the ECONOMY button (Fig.5 H).
The ECONOMY Indicator Lamp (green) (Fig. 3 7) will light.
ECONOMY operation begins.
To Stop the ECONOMY Operation
Press the ECONOMY button (Fig.5 H) again.
The ECONOMY Indicator Lamp (green) (Fig. 3 7) will go out.
Normal operation begins.
About ECONOMY Operation
● When ECONOMY operation mode is operated, the room temperature will be little higher than the set-temp under cooling mode.
Therefore, the ECONOMY mode is able to save more energy than other normal mode.
● In case of single-type, at the maximum output, ECONOMY Operation is approximately 70% of normal air conditioner operation.
● If the room is not cooled well during ECONOMY operation, select normal operation.
● During the monitor period in the AUTO mode, the air conditioner operation will not change to ECONOMY operation even if
ECONOMY operation is selected by pressing the ECONOMY operation button.
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Controller is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2) more than 3 sec-
onds and less than 10 seconds on the main unit control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2 2) once again.
(Controls are located inside the intake grille)
En-11
Left/right swing operation
Up/down/left/right swing operation
● Up/down/left/right swing: The airÀ ow-direction louvers move
(swing) in both the up/down and left/right airÀ ow directions.
● The SWING operation may stop temporarily when the air
conditioner's fan is not operating, or when operating at very
low speeds.
● If the SET button (Vertical) is pressed during the up/down
swing operation, the up/down swing operation will stop and
if the SET button (Horizontal) is pressed during the left/right
swing operation, the left/right swing operation will stop.
● Indicator Lamp
● When the air conditioner is operated
with the controls on the MANUAL AUTO
button, it will operate under the same
mode as the AUTO mode selected on
the Remote Controller (see page 7).
● The fan speed selected will be "AUTO"
and the thermostat setting will be stand-
ard. (24
OPERATION
TIMER
ECONOMY
: Lighting
: OFF
°C
)
Advertisement
Table of Contents
