Adding Liquid Fabric Softener - Whirlpool LSR7233DQ0 Use And Care Manual

Adding liquid fabric softener
Models with fabric softener dispenser installed
1. Add detergent and load clothes into the
basket.
2. Pour liquid fabric softener into the dis-
penser using the amount recommended
on the package. Avoid dripping or spilling
any fabric softener on the load.
3. Dilute fabric softener with warm water.
Fill dispenser with warm water until liquid
reaches the cross bar in the opening.
4. Start the washer. Diluted fabric softener
will be added to the load during the final
rinse.
NOTE: Do not stop the washer before the
rinse part of the cycle begins. Staining
can occur.
5. Flush dispenser periodically with warm
water, as illustrated.
• To remove the dispenser, grasp the top
of the dispenser with both hands.
Squeeze and push upward with thumbs
to remove.
• Clean dispenser by holding under water
faucet. Replace after cleaning.
NOTE: Do not wash clothes with this
dispenser removed. Do not add detergent
or bleach to dispenser. The dispenser is
for liquid fabric softener use only.
Models with no fabric softener
dispenser installed
• Always dilute fabric softeners with 1/2cup
(125 mL) to 1 cup (250 mL) warm water.
Undiluted fabric softener can stain fabrics.
• Add diluted fabric softener only in the final
rinse.
• Fabric softeners should not be mixed with
other laundry products because greasy
stains may form. If stains form, remove by
wetting the stain and rubbing with liquid
detergent or a bar of soap. Rewash the
stained item.
• Too much fabric softener can make some
items (diapers and towels) nonabsorbent.
If this happens, use less fabric softener, or
do not use it every time.
14