Troy-Bilt TB70SS Operator's Manual page 10

OPERATING THE EZ-LINK
TM
SYSTEM
The EZ-Link
TM
system enables the use of these optional
Add-Ons.
Cultivator ................................ TBGC
Edger ................................... TBLE
Hedge Trimmer ........................... TBAH
Straight Shaft Trimmer ...................... TBSS
Turbo Blower ............................. TBTB
Pole Saw ................................ TBPS
Brushcutter .............................. TBBC*
*Do NOT use this attachment with an electric
powered product.
WARNING:
Before you begin
using any
attachment, read and understand the manual
that came with the attachment. Follow all
safety information contained within.
Removing the Cutting Attachment or Add-Ons
1. Turn the knob counterclockwise to loosen (Fig. 9).
2. Press and hold the release button (Fig. 9).
3. While firmly holding the upper shaft housing, pull
the cutting attachment or add-on straight out of the
EZ-Link
TM
coupler (Fig. 10).
WARNING: To avoid serious
personal injury and
damage to the unit, shut the unit off before
removing or installing add-ons.
Installing the Cutting Attachment or Add-Ons
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a work
bench.
1. Turn knob counterclockwise to loosen (Fig. 9).
EZ-Link
TM
Coupler Release Button
Guide Recess
Fig. 9
2. While firmly holding the add-on, push it straight into
the EZ-Link
TM
coupler (Fig. 10).
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 9).
Release Button
EZ-Link
TM
Coupler
Primary Hole
Upper Shaft Housing Lower Shaft Housing
Fig. 10
3. Turn the knob clockwise to tighten (Fig. 11).
CAUTION: Lock the release
button in the primary
hole (Fig. 10) and securely tighten the knob
before operating this unit.
90° Edge
Trimming Hole
Fig. 11
CAUTION:
The add-ons with the
coupler system is to
be used in the primary hole only. Using the
wrong hole could lead to personal injury or
damage to the unit.
For decorative trimming/edging with the line head cutting
attachment, lock the release button of the cutting
attachment into the 90 ° hole (Fig. 11).
10