Thomas Aaron The Ultimate Slate Pool Table Owners & Installation Manual page 8

page 12
CAUTION! Be carefuJ to keep your fingers from
being caught between sJate and frame when
pJacing the slate on the table.
Place the first piece of end slate (P12) on top of the
frame FIG 6. Place it so that the indexing marks line
up with the edges of the frame FIG 6A.
Before putting the next piece of slate on the table,
visually make sure that the 4 slate bolt holes in the
slate line up with the 4 holes in the frame
or put 4 slate bolts (H5) into 4 slate bolt holes to
check alignment FIG 6A.
4 Slate Bolt
FIG
Step 6 Slate
Placement Next, place the middle piece of slate onto the table in position FIG 7
using the indexing marks for correct slate placement.
Next, place the third piece of slate on the table using the indexing
marks for correct slate placement FIG 7.
Next, check that all 12 slate bolt holes line up with all 12 holes in table
frame FIG 7A.
Next, bolt slate to frame with 12 slate bolts (H5) and 12 flanged wing
nuts (H6)in FIG 7 (hand tighten only).
Use the leg leveler wrench end that has a screw driver tip to hold the
bolt heads while tightening the wing nuts, See FIG 7A.
F! 7A
Step 7 Attaching
to Frame
_H5
I
page 13
Slate
H5