Step 12 Rail Assembly - Thomas Aaron The Ultimate Slate Pool Table Owners & Installation Manual

The ultimate slate pool table
Table of Contents

Advertisement

page 18
Locate the 6 rails and identify which ends of rails
are the corners and which are sides. Next, locate
all 6 pockets and identify the corner pockets and
side pockets. Follow the assembly steps below to
assemble rails and pockets in position, as show
below.
***Note _Always secure rail to slate with one
rail bolt and one domed rail washer in center
hole after rail is placed in position so it will
not fall off the table .***
Step 12 Rail Assembly
Rail/Pocket
Assembly
Step I -Assemble two Corner Pockets (P9) to End Rail (P4).
No hardware is needed to assemble pocket to rail. Place square pocket post into end
of rail and push firmly into rail. Place rail in position at end of table. At this time bolt the
rail to the slate with one rail bolt(H 1) and one domed rail washer (H3) up through slate
into center hole of rail FIG 12. Thread bolt in a few turns by hand, do not tighten at
this time.
Rail/Pocket
Assembly Step 2 - Place Left Rail (P2) into position on table as
shown in FIG 12. Hold corner pocket with one hand and slide the rail up to the
other hand, assembling rail and pocket together as previous step. Fasten rail to
slate with one rail bolt (H1) and domed rail washer (H3) FIG 12.
Rail!Pocket
Assembly
Step 3- Take one Side Pocket (pl0)
and assemble it to
H3
P10
H3
H3
IG t
t2
FIG t2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the The Ultimate Slate Pool Table and is the answer not in the manual?

This manual is also suitable for:

8 ut-hr-es

Table of Contents