Calibrating The Appropriate Settings Automatically - Sony DAV-HDX576WF Operating Instructions Manual

Calibrating the
Appropriate Settings
Automatically
[AUTO CALIBRATION]
D. C. A. C. (Digital Cinema Auto Calibration)
can set the appropriate surround sound
automatically.
• The system outputs a loud test sound when [AUTO
CALIBRATION] starts. You cannot turn the vohlme
down. Give consideration to children and neighbors.
• Make sure that the headphones are not connected to
the unit or surround amplifier. You cannot operate the
lbllowing Steps with the headphones connected.
1
Press FUNCTION +/- repeatedly until
"DVD" appears in the front panel
display.
2 Press C_ DISPLAY while the system is
in stop mode.
The Control Menu display appears on the
TV screen.
3 Press W4, to select _ [SETUP],
then press Q.
The options for ISETUP] appear.
4
Press ./4, to select [CUSTOM], then
press @.
The Setup Display appears.
5 Press W4, to select [AUDIO SETUP],
then press Q.
The options l\_r [AUDIO SETUP] appear.
6
Press 'I"/4, to select [AUTO
CALIBRATION], then press Q.
The options fin" [AUTO CALIBRATION]
appear.
7
Connect the calibration mic (supplied)
to the A.CAL MIC jack on the front
panel
Set up the calibration
mic at the ear level
using a tripod, etc. (not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction belv,,een the speakers and Ihe
calibralion mic.
L
mic
8
9
E,g,, DAV-HDX576WF
Press <.-/-) to select [YES].
Press @.
[AUTO CALIBRATION] starts.
Be quiet during the measurement.
• Before [AUTO CALIBRATION], make sure
that the surround amplifier turns on and you
install the surround amplifier in the appropriate
location. If you install the surround amplifier in
an inlproper location, such as another room,
proper measurement will not be obtained.
• Aw)id being in the measurement area and
making noise during the measurement (about 3
minute), to aw)id measurement failure. During
the measumment_ test signals are output from
the speakers.
• The environment of the room in which the
system is installed may affect measurements.
gOUs