Sony KP-53S55 Operating Instructions Manual page 6

Connecting an antenna/cable TV
system without a VCR
To cable or antenna
Cable
(Rear of projection TV)
VHF/UHF
Although you can use either an indoor antenna or
outdoor antenna with your projection TV, we
recommend connecting to an outdoor antenna or a
cable TV system for improved picture quality.
To an antenna
Connect your antenna cable to the VHF/UHF antenna
terminal. If you cannot connect your antenna cable
directry to the terminal, follow one of the instructions
below depending on your cable type.
A
(Rear of projection W)
VHF/UHF
• VHF only 75-ohm coaxial cable
or
• VHF/UHF
or
• Cable
To cable box
If your cable company requires you to connect a cable
box, make the connection as follows:
(Rear of projection W)
VHF/UHF
Cable box
B
(Rear of projection
"IV)
VHF/UHF
• VHF only 300-ohm twin lead cable
or • UHF only I
or
• VHF/UHF Antenna connector
C 75-ohm coaxial cable
• VHF J_
(Rear of projection
TV)
and
__D_ HF
EAC-66 U/V mixer
(not supplied)
• UHF [
300-ohm twin lead cable
Notes
• Most VHF/UHF combination antennas have a signal splitter.
Remove the splitter before attaching the appropriate connector.
• If you use the U/V mixer, snow and noise may appear in the
picture when viewing cable TV channels over 37(W+1).
6
I
Getting Started