Reverse Lockout Mechanism - Snapper 281323BVE Safety Instructions & Operator's Manual

Section 3- MAINTENANCE
WARNING I
DO NOT operate machine if interlock system is not
functioning properly, Contact your SNAPPER dealer I
immediately for assistance,
I
3.2 SERVICE - AFTER FIRST 5 HOURS
3.2.7. INTERLOCK SYSTEM
Check interlock controls for proper function:
The engine MUST NOT start if:
1. Blade Control is "ON" and/or clutch/brake pedal is
released.
The engine and blades MUST STOP if:
2. The operator leaves the operator position with Blade
Control "ON" and/or clutch/brake pedal is released.
3.2.8. REVERSE LOCKOUT MECHANISM
Check function of Reverse Lockout Mechanism with
engine off.
1. Depress and hold blade pedals.
2. Depress and hold clutch/brake pedal.
3. Shift lever must not go into reverse.
WARNING I
DO NOT operate machine if Reverse
Lockout I
Mechanism is not functioning properly, Contact your I
SNAPPER dealer immediately for assistance. I
3.2.9. LUBRICATION- GREASE FITTINGS
The following components on the Rear Engine Rider are
equipped with grease fittings and require periodic
lubrication. Apply General Purpose grease (NLGI No.2)
with a grease gun.
1. Front Wheel Bearings. Refer to Section "FRONT
WHEEL BEARINGS - LUBRICATION".
2, Rear Axle Bearing. Refer to Section "REAR AXLE
BEARING - LUBRICATION".
3. Mower Blade Spindle. Refer to Section "MOWER
BLADE SPINDLE - LUBRICATION".
3.3 SERVICE - EVERY 25 OPERATING HOURS
Perform all service required after the first 5 hours of
operation. Refer to Section "SERVICE - AFTER 5
HOURS".
3.3.1. CHECK ENGINE
1. Change engine oil. Refer to Section "CHANGE
ENGINE OIL". Refer to engine owner's manual for
oil specification.
2. Change air filter. Pull up and rotate the air cleaner
latch to remove cleaner cover. See Figure 3.4.
IMPORTANT: When cover is removed, you are
viewing the carburetor side of the air filter, which will
appear clean. Remove filter and pre-cleaner for
inspection.
BRIGGS ENGINE SHOWN
AIR CLEANER
LATCH
AIR CLEANER
COVER
FIGURE 3.4
3. Refer to engine owner's manual for cleaning and
service instructions. Remove and clean engine air
pre-cleaner. Remove and replace engine air
cleaner. See Figure 3.5. Install pre-cleaner and air
cleaner per engine owner's manual.
BRIGGS ENGINE SHOWN
AIR PRE-
CLEANER
AIR CLEANER
FIGURE 3.5
4. Reinstall air cleaner cover. Insert tabs located at
the bottom of the cover into corresponding slots in
engine cover. Position cover and engage latch over
cover and rotate and push down to lock.
IMPORTANT: The tabs on the air cleaner cover
must be completely inserted into engine cover or the
compartment will not be completely sealed to
prevent debris from entering into the carburetor.
16