Scag Power Equipment SW36-14KA Operator's Manual page 14

SCA6
TROUBLESHOOTING CUTTING CONDITIONS
CONDITION CAUSE CURE
.=
Uneven Cut on Fiat
Ground - Wavy
High-Low
Appearance,
Scalloped Cut, or
Rough Contour
Uneven Cut on
Uneven Ground -
Wavy Appearance,
High-Low Scalloped
Cut, or Rough Contour
f
i_i_i_i_ii_!!ii!i!i_i!iiiiliiiii_i_!i!i!i
............................... _......................................................................................... ::_:_:_!i_!i_!i_!i_!i_!i_!i_!_!!i!!_!!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i!!_!:_!!!i!!!i!i!i!i!i!i!i!i!i!i!i!i!i! ¸¸¸,,
Sloping Ridge Across
Width of Cutting Path
Lift worn off of blade
Blade upside down
Deck plugged, grass accumulation
Too much blade angle (deck pitch)
J Deck mounted improperly
Bent spindle area
Dull blade
Uneven ground
Tire pressures not equal
Wheels uneven
. Deck mounted incorrectly
y
ij
Y
Replace blade
Mount with cutting edge toward
ground
Clean underside of deck
Adjust pitch and level
See your authorized SCAG dealer
See your authorized SCAG dealer
Sharpen blade
May need to reduce ground speed,
raise cutting height, and/or change
direction of cut
Check and adjust tire pressure
Check and adjust tire pressure
See your authorized SCAG dealer
10