Table of Contents
Advertisement
PROG RAMMING
TH E REMOTE
The universal remote can be programmed
to control
most brands of
remote controllable
VCRs, satellite
receivers and cable boxes. The
remote is already programmed
to control most RCA, GE and PROSCAN
rvs, VCRs, DVD players, laserdisc players and satelrite receivers.
TESTING
THE
REMOTE
To determine
whether
the universal remote needs to be programmed,
turn a device ON, such as a VCR, point the remote at the VCR, and press
the VCR1 button.
Then press ON.OFF or CH ^ (channel up) or CH v
(channel down) to see if the VCR responds to the remote commands.
If
not, the remote needs to be programmed.
PROGRAMMING
THE
REMOTE
Using Automatic
Code Search
(_
l
The following
instructions can be used to program
the remote to
control each of the devices connected
to your TV. If you want to exit the
automatic code search without programming
any of your devices, press
and hold CLEAR until the LED turns off.
1.
Turn on the device you want to control (VCR, SAT, etc.).
2.
Press and hold the button
you want to program
(VCR1, VCR2, etc.}.
While holding the device button,
press and hold ON,OFF until the
red light on the remote turns on, then release both buttons.
3.
Press and release PLAY, then wait 5 seconds or until the LED stops
flashing,
At this point the remote is searching for the correct code to
program.
If, after 5 seconds, the device you want to control does
not turn off, press PLAY again to tell the remote to search the next
set of codes.
Continue
pressing PLAY until the device turns off or you have
searched through
all of the codes. There are 20 total sets of codes.
If the device does not turn off after pressing PLAY 20 times, then
the remote cannot control
that particular
device.
If the device you want to control
does turn off:
1.
Press and release REVERSE,then wait 2 seconds. Repeat this step
until the device turns back ON.
2.
To finish, press and hold STOP until the red light on the remote
turns off.
Using
Direct
Entry
1.
Turn on the component
to be programmed.
2.
Look up the brand and code number(s)
for the component
on the
code list on the last page of this section,
Using the Remote.
Note: Programming the remote will not
|
work with the AUX button in this model.
J
Dw
vcR2
A_x _AT,CAnLE
¢M +
. i Jx.
ra.
R_E_E
P_Y
You'll use these buttons when you
program the remote to control any
device.
The remote may not operate all models
of all brands.
24
Advertisement
Table of Contents
