Setting Up Your Eglide 2.2 Reader; Charge The Device; Battery Management; Turn The Device On/Off - Ematic EBW404 User Manual

Setting Up Your eGlide 2.2 Reader

Charge the device:

1 Plug the power adapter into an electrical wall outlet.
2 Connect the power adapter to the device's power interface port to fully charge
the battery before use (approximately 4 hours).
a. While charging, the battery charge indicator will show:
b. When fully charged, the battery FULL indicator will show:
NOTE: When the battery is out of power, wait at least 1 second before turning the
device ON again.
NOTE: The device can be used while the battery is charging, although the charging
time is longer when operating and charging at the same time.

Battery Management

The battery is not fully charged out of the box, so it is recommended you charge the
battery for at least 4 hours before you start to use the device.
The rechargeable battery is designed and manufactured to be used and recharged
frequently. As with all batteries, the capacity of the battery reduces each time it is
charged/depleted. However, you can still try to prolong the battery's lifetime by following
the suggestions below:
The lithium-ion battery has no need to discharge. It can be charged when the
reader still has some power.
When the reader is not in use, recharge the device every two weeks to maintain
maximum performance of the lithium ion battery.
Never leave the battery fully discharged for a long period of time.
Do not charge the reader under a high temperature environment (e.g. in sunlight.

Turn the device ON/OFF:

To turn the device ON:
1 Press and hold the POWER button until the Android bar is displayed.
2 Release the POWER button.
NOTE: It may take a few minutes for the system to start-up. Wait before
proceeding.
To turn the device OFF:
1 Press and hold the POWER button until the option to "Power OFF" is displayed.
2 Tap "Power OFF".
3 Tap "OK".
.
Using the eGlide Reader
.
| 9