Table of Contents
Advertisement
Step 3: Configuring
for a VCR
L
ff your TV is connected to a VCR, press OK.
If it is not, highlight
No and press
OK (a screen
will appear
reminding
you
to connect
your G-LINK cable
to your "IV and VCR.).
2.
Use the up and down arrow buttons to highlight the brand of your VCR that
is connected
to the TV and press OK.
If your brand
isn't listed,
highlight
Not Listed and press
OK.
.
Tune your VCR to channel 02. Next, turn OFF your VCR. When you
complete
these steps, press OK to begin testing.
Important
Note:
When code testing is in progress, don't touch your "IV,
VCR, or any of the remote controls for these products.
4.
Look at the front display of your VCR. If your VCR turned on automatically
and changed
to channel 09, the test was successful. Highlight
Yes and
press OK.
If your VCR didn't change to channel 09, you can either choose No or Test
this code again.
If you think your "1_ or remotes might have been touched
during the test,
tune your VCR to channel
02, turn off your VCR and highlight
Test this
code again.
If you don't
lhink
tim test was
interrupted,
highlight
No. Tune
your VCR to
channel
02 and
turn off your VCR. Press OK (tim GUIDE
Plus+
system
starts
testing
another
set of codes.)
Keep following the previous insu'uctions
until lhe VCR finds the
correct code.
Advertisement
Table of Contents
Troubleshooting
