Table of Contents
Advertisement
Advanced
Connections
Advanced
connections
give you better sound and video by separating
the audio and video signals and enabling
you to connect multiple
components.
This section describes the types of inputs available
on the back of your
TV and suggests ways you can use them for optimum
performance.
Once you have made your connections
you will need to program the TV to tune
to the correct Video INPUT channel in
order to see and hear audio and video
from the component.
You will program
this later in the Interactive
Setup.
Backofthe
TV
The diagram below describes each of the back panel jacks. When
connecting
A/V cables, be sure to connect corresponding
OUTPUTS and
INPUTS (Video to Video, Right Audio to Right Audio, etc.).
Input
1
Connect any of the following
components:
• VCR
• lnternet
Access Device
• Laserdisc Player
• DVD Player
• Satellite
Receiver
To view the component
connected
to Input 1:
Use the WHO.INPUT
button
on the remote.
Input
2
Connect any of the following
components:
. VCR
• Internet
Access Device
• Laserdisc Player
• DVD Player
• Satellite
Receiver
To view the component
connected
to Input 2:
Use the WHO,INPUT
button
on the remote.
TV
S-Video
This optional
connection
car
be used for
better video
quality picture.
External
Speaker
Jacks
Use to connect external
speakers for surround
sound.
Make sure the
Speaker Selection is set
to EXTERNAL.
S-Video
This optional
connection
can
be used for
better video
quality
picture.
Audio
Outputs
Connect to an audio receiver or
amplifier
for variable controlled
or fixed level stereo output.
Cable/Antenna
1
Takes the signal input from a cable,
cable box, or an off-air
antenna.
Can also
be used for basic component
connections.
VCR Control
Connect Guide
Plus+ Gold
controller
for one-
button
recording
and channel
tuning
from the
Guide.
6
Advertisement
Table of Contents
