Table of Contents
Advertisement
STARTUP
The steps below will get your TV connected
and ready for watching.
For
more details, refer to the sections listed.
CAUTION:
If you choose to use a stand with your TV, take precautions
that the
stand or other furniture the TV is placed on is properly located and
of adequate size and strength to prevent the TV from accidentally
being tipped over, pushed off, or pulled off. This could cause
damage to the TV and/or personal injury.
1. Hook up Your TV
See the "Connections"
section for details.
Hook up any antennas,
cables or other equipment
to your TV before you
follow
the steps below.
2. Plug in the TV
Plug the cord into a properly
grounded
outlet. See the Safety
Information sheet packed with your TV for more information.
3. Obtain
a Master Remote
A master remote (CRK17TD1) is required
for setup of many of the TV's
features.
Most of the operating
instructions
in this manual are
explained
using the master remote.
(A master remote can be purchased
from your distributor.
See the "Using the Remote"
section for details.)
4.
Put Batteries in the Remote
1.
Pull off the cover of the battery
compartment.
2.
Place the two AAA batteries
into the remote as shown at right,
matching
the + and-
end of each battery in the compartment.
3.
Replace the coven
3
Advertisement
Table of Contents
