Scheduled Maintenance - Genie TML-4000N Operator's Manual

Operator's Manual
MAINTENANCE
Check the Tires and Wheels
Bodily injury hazard. An over-
inflated tire can explode and may
cause death or serious injury.
Collision hazard. An excessively
worn tire can cause poor handling
and continued use could result in
tire failure.
Tip-over hazard. Do not use
temporary flat tire repair products.
Maintaining the tires and wheels in good condition
is essential to safe operation and good
performance. Tire and/or wheel failure could result
in a machine tip-over. Component damage may
also result if problems are not discovered and
repaired in a timely fashion.
1 Check the tire surface and sidewalls for cuts,
cracks, punctures and uneven or excessive
tread wear. Replace the tire if uneven or
excessive tread wear is found.
2 Check each wheel for damage, bends and
cracks. Replace the wheel if any damage is
found.
Tires and wheels must be replaced
with tires and wheels of the
specifications listed.
3 Check each tire with an air pressure gauge and
add air as needed.
12
4 Check the torque of each lug nut.
Tires and wheels - Standard and Narrow models
Tire size
Rim size
Lug nut torque
Tire pressure (cold)

Scheduled Maintenance

Maintenance performed quarterly, annually and
every two years must be completed by a person
trained and qualified to perform maintenance on
this machine according to the procedures found in
the service manual for this machine.
Machines that have been out of service for more
than three months must receive the quarterly
inspection before they are put back into service.
Genie TML-4000 and TML-4000N
Third Edition • Second Printing
ST185/80D13
13 x 4.5 in 33 x 11.4 cm
80 ft-lbs
50 psi
Part No. 97600
108 Nm
3.4 bar