Front Panel Features; Rear Panel Features - Eden WT-550 World Tour Series Operation Manual

FRONT PANEL FEATURES

Input Jack
– Designed to accept a
standard ¼ inch mono phone plug. For best
results, use a high-quality, shielded cable to
connect your instrument to the amplifier.
Input Pad
– By pulling the Gain control
knob out, you engage a –12db pad, which
will prevent the system from being
overdriven by high-output instruments.
Pad Indicator
– Lights to indicate that the
pad is engaged.
Gain Control
– Regulates the first gain
stage of the preamplifier and controls the
amount of signal available to the system.
Set Level Indicator
– Lights to indicate
that the preamp is sitting right on the sweet
spot of the gain balance and is at optimum
signal to noise as well as best overall head
room.
Compressor Indicator
indicate that the signal has crossed the
threshold of the compression circuit and that
compression is taking place.
Compressor Bypass
enhance knob out will disengage the
compressor.
Enhance Control
– Called the "Magic
Knob" by some, this complex control
simultaneously boosts the very low-bass,
upper middle, and high frequencies while
putting a dip in the lower middle frequencies.
It is flat when set to its minimum level.
Tone Control Section
Bass
– This traditional shelving tone control
provides 15 db of boost or cut at 30 hz.
Quasi-Parametric Tone Control
These three pairs of controls, with
overlapping frequencies, allow you to boost
or cut the tone at the desired frequency
center. The one octave fixed bandwidth
(Q=1) allows the controls to interact
smoothly and musically.
Frequency control
– Provided for low,
mid, and high frequency ranges, these
– Lights to
– Pulling the
–
controls select the frequencies you wish to
boost or cut.
Boost/Cut Controls
– Located beneath
each frequency selection control, these
controls will boost or cut the selected
frequency by 15 db. They are flat at their
12:00 setting.
Treble
– This is a traditional shelving-type
tone control. It provides 15 db of boost or
cut. The knee of the filter is at
approximately, 2KHz. The control is flat at
the 12:00 position.
EQ Clip Indicator
– Flashes to indicate
clipping within the tone control circuit of the
preamplifier. This should never be lit up.
Master Level Control
system output.
Headphone Jack
– Accepts standard ¼
stereo or mono headphone plug.
Output Limit Indicators
indicate activity of the power amplifier
limiting circuit, which protects the speaker
system from severe distortion. This LED
indicates that the amplifier has reached its
maximum output level.
On/Off Switch
– This switch turns the
system power on or off. The switch
illuminates to indicate the presence of
current prior to the fuse.

REAR PANEL FEATURES

Combination Power Cord Jack and
Fuse Holder
– The removable power cord
is attached here. Pulling the holder out of
the top of the power inlet accesses the fuse
carrier. Your unit was shipped with a spare
fuse inserted in the fuse carrier. USE ONLY
THE SAME SIZE AND TYPE FOR
REPLACMENT. U.S. users should make
sure the fuse holder is installed so FUSE
should be right side up. European models
also come with a holder marked (FUSE)
they are configured for 230 / 240 only and
must be adapted by a service tech for U.S.
standard voltage. The standard fuse for U.S.
use is (8) Amp slow blow or time delay. In
Europe use (4) Amp slow Blow. For other
voltages and to make changes Please refer
– Adjusts overall
– Lights to
3