Systems Indicator Monitor; Pto(Bladeengage) Lever; Decklift Lever; Parking Brakebutton - Yard-Man 604 Operator's Manual

Systems Indicator Monitor
Your tractor is equipped with a ammeter as part of its
systems indicator monitor. Locate the monitor on the
left side of your dash panel and compare it to Figure 11.
Ammeter-
DP
SV
%
Oil
Brake
PTO
Figure 11
If the Brake light or PTO light illuminates when
attempting to start the unit, proceed as follows:
BRAKE -- Depress the brake pedal.
PTO -- Move PTO (Blade Engage) lever into the
disengaged (OFF) position.
NOTE:
It is normal for the Oil light and the Battery light
to ifluminate while the engine is cranking, but if either
illuminate's while the engine is running, proceed as
follows:
OIL-- Stop the tractor immediately and check
the crankcase oil level as instructed in
the Briggs & Stratton Operator/Owner
Manual included with your tractor.
BATTERY-- The battery is in need of a charge, or the
engine's charging system is not
generating sufficient amperage. Refer to
the MAINTENANCE s ection of this manual
for the proper battery charging procedure
or have the charging system checked by
a Briggs & Stratton engine's dealer.
The ammeter measures the electrical output of the
engine's charging system. Under normal operating
conditions, with the engine at full throttle, the ammeter's
needle should measure a positive charge.
PTO(BladeEngage) Lever
PTO / BLADE
PTO
ENGAGE
The PTO (Blade Engage) lever is located on the left
side of the dashboard next to the steering wheel. Move
the PTO (Blade Engage) lever forward to engage the
power to the cutting deck or other (separately available)
attachments; move the PTO (Blade Engage) lever
rearward to disengage the power to the attachments.
NOTE:
The PTO (Blade Engage) lever must be in the
disengaged (OFF) position when starting the engine,
when traveling in reverse and if the operator leaves the
seat.
SeatAdjustment L ever
To adjust the seat forward or backward on units
equipped with a quick-adjust seat, slide the seat
adjustment lever to the left and reposition the seat to
the desired position. Once a comfortable position is
found, release the seat adjustment lever to lock the
seat in place. Refer to SeatAdjustment on page 20 of this
manual for more detailed instructions.
DeckLift Lever
Found on your tractor's right fender, the deck lift lever is
used to change the height of the cutting deck. To use,
move the lever to the left, then place in the notch best
suited for your application.
Parking BrakeButton
To set the parking brake, fully
depress the brake pedal and
push the parking brake button in.
Hold the button in while taking
your foot off the brake pedal.
Both the parking button and the
brake pedal will then stay
depressed. To release the
parking brake, depress the brake
pedal slightly. The parking brake
button will then return to its original position.
NOTE:
The parking brake must be set if the operator
leaves the seat with the engine running or the engine
will automatically shut off.
IMPORTANT: Always set the parking brake when
leaving the tractor unattended.
13