Mixed Loads; Drying Times; End-Of-Cycle; Lint Signal - Whirlpool LE6090XS Use & Care Manual

Mixed loads Drying times
When drying a load with different
kinds and weights of fabrics, use the
cycle suggested for the lightest fab-
rics. When the dryer stops, remove dry
items and reset the control.
To reduce wrinkling, take the load
from dryer as soon as tumbling stops.
This is important for permanent press,
knits and synthetic fabrics.
Drying times will vary depending on:
• amount of moisture in the clothes.
• type and weight of the fabric.
• size of load,
• room temperature around the dryer.
• temperature of the wash rinse water.
• amount of lint in the lint screen,
• dryer temperature selection.
See your "Dryer Guide" for more
information.
End-of-cycle signal
The dryer sounds o signal to let you know when
the cycle is finished. The signal cannot be turned
off and is not adjustable.
The signal is helpful when you are drying per-
manent press, synthetics and other items that
should be taken out as soon as the dryer stops.
Lint signal
Clean lint screen before each load. If you
neglect to clean your lint screen, the signal will
sound. The (whistle tone) signal lets you know
the air flow is being restricted. Restricted air flow
reduces drying efficiency.
Turn offthe dryer and clean the lint screen as
shown on page 9.