Sharp 27SF56B Operation Manual page 12

Please note: your new Television is capable of receiving the full
range of AIR-3"V channels available today, from the most advanced
digital channels, to the more traditional analog channels. As the
transition toward full digital TV continues, some AIR-TV systems
in the USA will have a mixture of analog and digital channels in
their lineups.
[] You can change channels in several ways.
- REMOTE
KEYPAD
FLASHBACK
CHANNEL
- UP(A)/
DOWN (_)
Method 1
Using CH A/V on the remote
control unit or on the TV set
(On the Set)
r
CH AI_"
buttons
(while viewing
digital channel)
10
At{ALO_
4:3 IDOl
TVPG DL_V
QSI"ERE0 _Ol_ AI
SAP _-ON A_R
_hile viewing analog channel)
Method 2
(i) Press FLASHBACK to switch to the previously tuned channel.
(ii) Press FLASHBACK again to switch back to the currently tuned channel.
• FLASHBACK will not work if no channel has been changed after TV is turned on.
Fb_SHBACE
(D
Method 3
Using REMOTE KEYPAD buttons (0-g and ENTER) to select up to 125 channels for VHF/UHF/
CATV,
TO select a 1 or 2-digit analog channel number (e, g,, Channel 5):
Press 5 -+ ENTER
IQ ® :ol
tQ ® ®1
, When selecting a 1-digit channel number, it is not necessary to press 0 before the number
o When you enter 0-9 only, channel selection will be made if there is no operation for a few seconds..
To select a 3-digit analog cable channel number (e. g., Channel 115):
Press 1 -_ 1 --> 5
= When you enter 0-9 only, channel selection will be made if there is no operation for a few seconds..
o If you push "0" by itself, nothing wilt happen
To select a digital channel number (e. g. Channel 10.1):
Press 1 -> 0 --> • (DOT) --> 1 -_ ENTER
• Complete the above steps within a few seconds
o When you enter 0-9 and • (DOT), channel selection will be made if there is no operation for a few
seconds
12