Cleaning And Care; Specifications - Sharp Carousel II R-3A84 Operation Manual

Exterior
The outside surface is precoated metal and plastic Clean the outside with mild soap and water; rinse and dry with a soft cloth
Do not use any type of household or abrasive cleaner
Door
Wipe the window on both sides with a damp cloth to remove any spills or spatters, Metal
parts will be easier to maintain if wiped frequently with a damp cloth. Avoid the use of
harsh abrasives.
Touch Control Panel
Care should be taken in cleaning the touch control panel If the control panel becomes
soiled, open the oven door before clea ning Wipe the panel with a cloth dampened slightly
with water only Dry with a soft croth Do not scrub or use any sort of chemical cleaners
Close door and touch STOP/CLEAR
Interior
Cleaning is easy because no heat is generated to the interior surfaces; therefore, there
is no baking and setting of spills or spattering To clean the interior surfaces, wipe with
a soft cloth and warm water_ DO NOT USE ABRASIVE OR HARSH CLEANERS OR
SCOURING PADS For heavier soil, use baking soda or a mild soap; rinse thoroughly
with hot water.
Wave Guide Cover
Carefully wash any food particles from the wave guide cover located on the ceiling in the
oven cavity
Odor Removal
Occasionally, a cooking odor may remain in the oven. To remove, combine 1cup water,
grated peel and juice of 1 lemon and several whole cloves in a 2 cup glass measuring
cup Boil for several minutes using 100% power Mow to set in oven until cool Wipe
interior with a soft cloth
Turntable/Turntable
support
The turntable and turntable support can be removed for easy cleaning, Wash them in
mild, sudsy water; for stubborn stains use a mild cleanser and scouring sponge as
described above They are also dishwasher-proof The turntable motor shaft is not
sealed, so excess water or Spills should be wiped up immediately..
AC Line Voltage:
AC Power Required:
Output Power:
Microwave
Frequency:
Outside Dimensions:
Cavity Dimensions:
Oven Capacity:
Cooking Uniformity:
Weight:
Single phase 120V, 60Hz, AC only
1350 watts 12.0 ampsr
800 watts*(IEC-705-1988 Test Procedure)
2450 MHz
20 1/2"(W) x 11 5/8"(H) x 15 1/4"(D)
13 3/4"(W) x 7 3/4"(H) x 14 !/2"(D)
09 cft
Turntable system
Approx.. 33 Ibs
,k the International Etectrotechnical Commission's standardized method for measuring output wattage This test method is
widely recognized
In compliance with standards set by:
FCC - Federal Communications Commission Authorized.,
DHHS - Complies with Department of Health and Human Services (DHHS) rule, CFR, Title 21, Chapter I, Subchapter J.
Q- symbol on nameplate means product by Underwriters Laboratories, Inc.
This the the is listed
18