Sanyo CLT1554 Owner's Manual page 2

CAUTION
- - • - ® me • e-
CAUTION: TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS fNSIDE. REFER SERVICING TO QUALIFIED
SERVfCE PERSONNEL
THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK
__NIDM_IANTHIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND MAIN I_
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS
TO RAIN OR IVIONSTURE.
IMPORTANT SAFETY INSTRUCTIONS
Important Safety instructions for LCD'IV
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other.A grounding-type plug has
two blades and a third grounding prong. The wide blade
or the third prong are provided for your safety. If the
provided plug does not fit fully into your outlet, consult
an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11. 0nly use attachments/accessories specified by the
manufacturer.
12. Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination
to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when
unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servic-
ing is required when the apparatus has been damaged in
any way, such as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally,or has beendropped.
15. If an outside antenna is connected to the television
equipment, be sure the antenna system is grounded so
as to provide some protection against voltage surges
and built up static charges. In the U.S. Selection 810-21
of the National Electrical Code provides information with
respect to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location
of antenna discharge unit, connection to grounding elec-
trodes, and requirements for the grounding electrodes.
EXAMPLE OFANTENNA GROUNDING ASPER(NEC) N ATIONAL
ELECTRICAL CODE
kNTENNA
_--- LEAD IN
WIRE
_ GROUND
_-- -- -- CLAMP
. . - ANTENNA
i _y_,_j../!_
DISCHARGE UNIT
,NED SECT,ON8
GROUND CLAMPS .... GROUNDING CONDUCTORS
POWER SERVICE GROUNDING _v (NED SECTION 810-21)
ELECTRODE SYSTEM
(NEC ART 258, PART H) NEe - NATIONAL ELECTRICAL CODE
Note to OATV system installer:
This reminder is provided to direct the CATV system installers attention to Article
820-40 of the NEC that provides guidelines for proper grounding and, in particu-
lar, specifies that the cable ground shall be connected to the grounding system of
the building, as dose to the point of cable entry as practJca]
16. An outside antenna system should not be located in the
vicinity of overhead power lines or other electrical light
or power circuits, or where it can fall into such power
lines or circuits. When installing an outside antenna
system, extreme care should be taken to keep from
touching such power lines or circuits as contact with
them might be fatal.
2 Important Safety Information