Setting Up The Refrigerator; Removing The Refrigerator Doors - Samsung RF268ABWP/XAA User Manual

SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between it and the wall.
Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly
chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is sufficiently cool.
Check the accessories listed below.
Water filter Hex wrench Fastener
Compression fitting Compression nut Clip fitting lock(red)
Required Tools (Not provided)
Philips screwdriver(+) Flat-blade screwdriver(-) Socket wrench (10mm)
Pliers
Allen wrench(3/16")
REMOVING THE REFRIGERATOR DOORS
Some installations require door removal to transport the Refrigerator to its final location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer, make sure you read
following items.
A
WARNING
Disconnect power to the Refrigerator before removing the door or drawer.
o
o
o
Be careful not to drop, damage or scratch the door/drawer while removing them.
Be careful not to get injured while removing the door/drawer.
Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the Refrigerator doors
A Be careful not to drop and scratch the doors while removing the
WARNING
doors.
Disassemble the Refrigerator doors
1. With the door opened, remove the cap top table ( 1 ) with
a flat-blade screwdriver(-), and close the door.
Remove the 3 screws holding down the top table ( 2 ) and
remove it.
Setti]g up 9