Samsung RF266AB User Manual page 18

4. Remove the filter cap and insert the filter into the filter
housing.
5. Slowly turn the water filter 90 ° clockwise to align with the
printing mark on the cover, locking the filter in position.
Make sure to align the water filter label mark with center of
cover filter printing as illustrated. Remember, do not over-
tighten.
//
.....Separation
of red cap,
Turn until the label
aligned,
[_You should remove the right side upper glass shelf before installing water filters.
®
Removing any residual matter inside the water
supply line after installing the water filter.
1. Turn ON the main water supply & turn OFF the valve to
the water supply line.
2. Run water through the dispenser until the water runs clear
(approx. 6-7 minutes). This will clean the water supply
system and remove air from the lines.
3. Additional flushing may be required in some households.
4. Open the Refrigerator door and make sure there are no
water leaks coming from the water filter.
Be sure to flush the dispenser thoroughly or water may drip from the dispenser.
This is due to the fact that there is still air in the line.
A Test button
CAUTION In case ice doesn't come out, pull out the ice bucket and press test button located on the right side of ice
maker.
Test button
18 Settisg Up