Samsung UN40F6300 E-Manual page 83

(HDMI-CEC)
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
Only one external device may be connected to Receiver.
Check if the power cord of the Anynet+ device is properly connected.
Check the cable connections of the Anynet+ device.
Anynet+ does not Navigate to the System menu and verify that Anynet+ (HDM_-CEC) is set to On.
work. Check whether the TV remote control is in TV mode.
Check whether the remote control is Anynet+ compatible.
Anynet+ may not function under certain circumstances. (Searching channels,
operating Smart Hub or Setup, etc.)
If you have disconnected and then reconnected the HDMI cable, scan for devices
again or turn your TV off and on.
Check if the Anynet+ device is properly connected to the TV and then navigate to
I want to start the System menu to see if Anynet+ (HDM_-CEC) is set to On.
Anynet+. After checking, select the Virtual Remote panel's TOOLS button to display the list.
Select Anynet+ (HDMJ=CEC) from the list.
I want to exit Anynet+ Select View TV from the Anynet+ menu.
" Select a non-Anynet+ device from Source.
The message
"Connecting to
Anynet+ device..."
or "Disconnecting
from Anynet+ device"
appears on the screen.
i
You cannot use the remote control when you are configuring Anynet+ or switching
to a viewing mode. Use the remote control after the TV has completed the Anynet+
configuration or has switched to a viewing mode.
The Anynet+ device
You cannot use the play function when Setup is progress.
won't play.
Check whether the device supports Anynet+.
Check whether the HDMI cable is properly connected.
Navigate to the System menu and verify that Anynet+ (HDM_-CEC) is set to On.
Scan for Anynet+ devices again.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the
device is connected to your TV with an HDMI cable. Some HDMI cables may not
support Anynet+.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
The connected device
is not displayed.
The TV audio is not Connect an optical cable to the TV and the receiver.
being played through ARC enables digital sound to be output via the HDMI (ARC) port.
the receiver. However, ARC is only available when the TV is connected to an audio receiver that
supports ARC.