Refrigerator Doors; Required Tools - Samsung RF261B Series User Manual

Hide thumbs Also See for RF261B Series:
Table of Contents

Advertisement

Available languages

Available languages

÷
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor. This surface
should be strong enough to support a fully loaded
refrigerator, or approximately 3311bs (150kg).
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When
moving the refrigerator, you need to pull and push
it straight forwards or back. Do not wiggle it from
side to side.
ACCESSORIES
AND
REQUIRED
TOOLS
The following accessories are included with your
refrigerator:
Hexwrench
Fastener
Required
Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips
Flat-blade screw
Socket wrench
screwdriver(+)
driver(-)
(10ram)
Allen wrench
Pliers
(3/16")(5mm)
REMOVING
THE
REFRIGERATOR
DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its final location. Do not remove
the doors/drawer if you don't need to. If you do
not need to remove the refrigerator doors, go
to Adjusting the Level on page 9. if you need to
remove the doors, continue below.
Before removing the door/drawer,
make sure you
read the following items:
z_
Disconnect power to the refrigerator before
WARNING
removing the door or drawer.
• Be careful not to drop, damage or
scratch the door/drawer
while removing
them.
Be careful not to get injured while removing the
door/drawer.
Reattach the door/drawer
properly to avoid:
Moisture from air leakage.
Uneven door alignment.
Wasting energy due to improper door seal.
Disassemble
the refrigerator
doors
AR_N_N Be careful not to drop and scratch the
w
G doors while removing the doors.
With the door opened
1. Remove 3 screws holding down the TOP
TABLE ( 1 ) and turn it with wires connected.
2. Disconnect two connector ( 2 ) on the left side
door. To remove the water coupler from the
hinge, twist and pull it from the hinge.
÷
setting up 07
DA68-02601B(EN+ES+FR)-0.O.indb
7
_
2012.3.29
9:28:31
AM

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rf260b series

Table of Contents